JN516X Datasheet, PDF (70/94 Pages) NXP Semiconductors – IEEE802.15.4 Wireless Microcontroller

Radio Parameters: 2.0-3.6V, +25ºC
Parameter
Min
Typical
Max
Unit
Receiver Characteristics
Receive sensitivity
-92
-95
dBm
Maximum input signal
+10
dBm
Adjacent channel
rejection (-1/+1 ch)
19/34
dBc
[CW Interferer]
Alternate channel
rejection (-2/+2 ch)
[27/49]
40/44
dBc
[CW Interferer]
[54/54]
Other in band rejection
48
dBc
2.4 to 2.4835 GHz,
excluding adj channels
Out of band rejection
52
dBc
Spurious emissions
(RX)
Intermodulation
protection
dBm
<-70
-65
-60
40
dB
RSSI linearity
Transmit power
Output power control
range
Spurious emissions
(TX)
EVM [Offset EVM]
Transmit Power
Spectral Density
-4
+4
dB
+0.5
Transmitter Characteristics
+2.5
dBm
-35
dB
-40
13 [2.5]
-38
<-70
<-70
-20
dBm
%
dBc
Notes
Nominal for 1% PER, as per
802.15.4 Section 6.5.3.3
For 1% PER, measured as
sensitivity
For 1% PER, with wanted signal
3dB, above sensitivity. (Note1,2)
(modulated interferer)
For 1% PER, with wanted signal
3dB, above sensitivity. (Note1,2)
(modulated interferer)
For 1% PER with wanted signal
3dB above sensitivity. (Note1)
For 1% PER with wanted signal
3dB above sensitivity. All
frequencies except wanted/2 which
is 8dB lower. (Note1)
Measured conducted into 50ohms
30MHz to 1GHz
1GHz to 12GHz
For 1% PER at with wanted signal
3dB above sensitivity. Modulated
Interferers at 2 & 4 channel
separation (Note1)
-95 to -10dBm.
Available through Hardware API
In three 12dB steps (Note3)
Measured conducted into 50ohms
30MHz to 1GHz,
1GHz to12.5GHz,
The following exceptions apply
1.8 to 1.9GHz & 5.15 to 5.3GHz
At maximum output power
At greater than 3.5MHz offset, as
per 802.15.4, Section 6.5.3.1
70
JN-DS-JN516x v1.1 Production
© NXP Laboratories UK 2013