MC68340AB16E Datasheet, PDF (359/441 Pages) Motorola, Inc – Integrated Processor with DMA User’s Manual

Freescale Semiconductor, Inc.
COUNTER
CLOCK
COUNTER 0
f
f
f
f
f
f
f
f
f
f
f
f
f
f
f
f
e
d
c
b
TGATE
ENABLE
MODEx Bits in Control Register = 110
TGE Bit of the Control Register = 1
0
0
0
0
0
0
f
f
0
0
0
0
0
0
f
f
0
0
0
0
0
0
f
f
2
1
1
1
1
0
f
e
TG BIT SET
TIMEOUT
TO BIT SET
Figure 8-10. Event Count Mode
The timer is enabled by setting the SWR and CPE bits in the CR and, if TGATE≈ is
enabled (TGE bit of the CR is set), then asserting TGATE≈. When the timer is enabled,
the SR ON bit is set. On the next falling edge of the counter clock, the counter is loaded
with the value of $FFFF. With each successive falling edge of the counter clock, the
counter decrements. The PREL1 and PREL2 registers are not used in this mode.
If TGATE≈ is not enabled (CR TGE bit is cleared), then TGATE≈ does not start or stop
the timer or affect the TG bit of the SR. In this case, the counter would begin counting on
the falling edge of the counter clock immediately after the SWR and CPE bits in the CR
are set.
If TGATE≈ is enabled (CR TGE bit is set), then the assertion of TGATE≈ starts the
counter. The negation of TGATE≈ disables the counter, sets the SR TG bit, and clears the
ON bit in the SR. If TGATE≈ is reasserted, the timer resumes counting from where it was
stopped, and the ON bit is set again. Further assertions and negations of TGATE≈ have
the same effect. The TGL bit in the SR reflects the level of TGATE≈ at all times.
If the counter counts down to the value stored in the COM register, the COM and TC bits
in the SR are set. If the counter counts down to $0000, a timeout is detected. This event
sets the TO in the SR and clears the COM bit. At timeout, the next falling edge of the
counter clock reloads the counter with $FFFF. TOUTx transitions at timeout or is disabled
as programmed by the CR OC bits. The SR OUT bit reflects the level on TOUTx.
To determine the number of cycles counted, the value in the CNTR must be read,
inverted, and incremented by 1 (the first count is $FFFF which, in effect, includes a count
of zero). The counter counts in a true 216 fashion. For measuring pulses of even greater
duration, the value in the POx bits in the SR are readable and can be thought of as an
extension of the least significant bits in the CNTR.
MOTOROLA
MC68340 USER’S MANUAL
8-15
For More Information On This Product,
Go to: www.freescale.com