LAN9116 Datasheet, PDF (101/109 Pages) SMSC Corporation – Highly Efficient Single-Chip 10/100 Non-PCI Ethernet Controller

LAN9116
TABLE 7-1: POWER CONSUMPTION DEVICE ONLY (CONTINUED)
Mode
Total Power - Typical (mW)
D1, 100BASE-T /w traffic
262
D1, Idle
262
D2, Energy Detect Power Down (Cable 35
disconnected)
D2, General Power Down
11
Note 7-4 Each LED indicator in use adds approximately 4 mA to the Digital power supply.
Note 7-5 D0 = Normal Operation, D1 = WOL (Wake On LAN mode), D2= Low Power Energy Detect.
7.4 Power Consumption Device and System Components
This section describes typical power consumption values of a total Ethernet LAN connectivity solution, which includes
external components supporting the Microchip Ethernet controller. The values below should be used as comparison
measurements only for power provisioning.
Please refer to application note “AN 12-5 Designing with the LAN9118 - Getting Started”, that can be found on Micro-
chip’s web site www.microchip.com, which details the magnetics and other components used.
Power measurements taken under the following conditions:
Temperature: .......................................................................................................................................................... +25 C
Device VDD: .........................................................................................................................................................+3.30 V
TABLE 7-2: POWER CONSUMPTION DEVICE AND SYSTEM COMPONENTS
Mode
Total Power - Typical (mW)
10BASE-T Operation
D0, 10BASE-T /w traffic
614
D0, Idle
637
D1, 10BASE-T /w traffic
513
D1, Idle
513
D2, Energy Detect Power Down
56
D2, General Power Down
32
100BASE-TX Operation
D0, 100BASE-TX /w traffic
518
D0, Idle
576
D1, 100BASE-T /w traffic
414
D1, Idle
414
D2, Energy Detect Power Down
56
D2, General Power Down
32
Note 7-6 Each LED indicator in use adds approximately 4 mA to the Digital power supply.
 2005-2016 Microchip Technology Inc.
DS00002268A-page 101