SAM4L_14 Datasheet, PDF (105/176 Pages) ATMEL Corporation – Technology for Ultra-low Power Consumption

ATSAM4L8/L4/L2
Table 9-7. ATSAM4L8 Current consumption and Wakeup time for power scaling mode 0 and 2
Mode
SLEEP0
Conditions
Switching mode
T_A
25°C
85°C
Typical
Wakeup Time
9 * Main clock
cycles
Typ
3817
4050
Max ⁽¹⁾
4033
4507
Unit
SLEEP1
Switching mode
25°C
85°C
9 * Main clock
cycles + 500ns
2341
2525
2477
2832
SLEEP2
Switching mode
25°C
85°C
9 * Main clock
cycles + 500ns
1758
1925
1862
1971
SLEEP3
Linear mode
51
60
WAIT
OSC32K and AST running
Fast wake-up enable
OSC32K and AST stopped
Fast wake-up enable
6.7
µA
1.5µs
5.5
RETENTION
OSC32K running
AST running at 1kHz
25°C
3.9
1.5µs
AST and OSC32K stopped
3.0
BACKUP
OSC32K running
AST running at 1kHz
AST and OSC32K stopped
1.5
3.1
0.9
1.7
1.
These values are based on characterization. These values are not covered by test limits in production.
9.5.2
Power Scaling 1
The values in Table 34-7 are measured values of power consumption under the following condi-
tions, except where noted:
• Operating conditions for power scaling mode 1
– V_VDDIN = 3.3V
• Wake up time from low power modes is measured from the edge of the wakeup signal to the
first instruction fetched in flash.
• Oscillators
– OSC0 (crystal oscillator) and OSC32K (32kHz crystal oscillator) stopped
– RCFAST Running at 12MHz
• Clocks
– RCFAST used as main clock source
– CPU, AHB clocks undivided
– APBC and APBD clocks divided by 4
– APBA and APBB bridges off
– The following peripheral clocks running
• PM, SCIF, AST, FLASHCALW, APBC and APBD bridges
42023GS–SAM–03/2014
105