TLK3114SA_13 Datasheet, PDF (49/66 Pages) Texas Instruments – 10-Gbps XAUI Transceiver

BIT(S)
15
14
13
12
11
10
9
8
7
6
5
4
3
2
1
0
Table 3−23. Channel Status Register (Register 22)
NAME
DESCRIPTION
Channel D transmit FIFO
collision error
1 = Collision error is detected to cause the transmit FIFO self reset.
0 = No error (default)
After being read, this bit is reset to 0.
Channel C transmit FIFO
collision error
1 = Collision error is detected to cause the transmit FIFO self reset.
0 = No error (default)
After being read, this bit is reset to 0.
Channel B transmit FIFO
collision error
1 = Collision error is detected to cause the transmit FIFO self reset.
0 = No error (default)
After being read, this bit is reset to 0.
Channel A transmit FIFO
collision error
1 = Collision error is detected to cause the transmit FIFO self reset.
0 = No error (default)
After being read, this bit is reset to 0.
Channel D decode error
1 = Code word or running disparity error detected.
0 = No error (default)
After being read, this bit is reset to 0.
Channel C decode error
1 = Code word or running disparity error detected.
0 = No error (default)
After being read, this bit is reset to 0.
Channel B decode error
1 = Code word or running disparity error detected.
0 = No error (default)
After being read, this bit is reset to 0.
Channel A decode error
1 = Code word or running disparity error detected.
0 = No error (default)
After being read, this bit is reset to 0.
Channel D PRBS pass
1 = PRBS testing passes without error (default).
0 = Error is detected during PRBS test.
After PRBS_PASS has been cleared, reading this bit sets it to 1.
Channel C PRBS pass
1 = PRBS testing passes without error (default).
0 = Error is detected during PRBS test.
After PRBS_PASS has been cleared, reading this bit sets it to 1.
Channel B PRBS pass
1 = PRBS testing passes without error (default).
0 = Error is detected during PRBS test.
After PRBS_PASS has been cleared, reading this bit sets it to 1.
Channel A PRBS pass
1 = PRBS testing passes without error (default).
0 = Error is detected during PRBS test
After PRBS_PASS has been cleared, reading this bit sets it to 1.
Channel D LOS output
1 = LOS condition is reported.
0 = No LOS (default)
After being read, this bit is reset to 0.
Channel C LOS output
1 = LOS condition is reported.
0 = No LOS (default)
After being read, this bit is reset to 0.
Channel B LOS output
1 = LOS condition is reported.
0 = No LOS (default)
After being read, this bit is reset to 0.
Channel A LOS output
1 = LOS condition is reported.
0 = No LOS (default)
After being read, this bit is reset to 0.
READ/WRITE
Read-only
Read-only
Read-only
Read-only
Read-only
Read-only
Read-only
Read-only
Read-only
Read-only
Read-only
Read-only
Read-only
Read-only
Read-only
Read-only
3−30