English
Language : 

TCM4400 Datasheet, PDF (15/72 Pages) Texas Instruments – GSM/DCS BASEBAND AND VOICE A/D AND D/A RF INTERFACE CIRCUIT
2 Electrical Specifications
2.1 Absolute Maximum Ratings Over Operating Free-Air Temperature Range
(Unless Otherwise Noted)†
Supply voltage range, AVDD, DVDD (see Note 1) . . . . . . . . . . . . . . . . . . . . . . . – 0.3 to 6 V
Maximum voltage on any input, VI max . . . . . . . . . . . . . . . . . . . VDD +0.3 V / VSS – 0.3 V
Storage temperature, Tstg . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . – 65°C to 150°C
Maximum junction temperature, TJ . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 150°C
† Stresses beyond those listed under “absolute maximum ratings” may cause permanent damage to the device. These
are stress ratings only, and functional operation of the device at these or any other conditions beyond those indicated
under “recommended operating conditions” is not implied. Exposure to absolute-maximum-rated conditions for
extended periods may affect device reliability.
NOTE 1: Voltage measurements in respect to GND
2.2 Recommended Operating Conditions
Supply voltage range (AVDD, DVDD)
Supply extended voltage range for RF blocks (AVDD3/5) – 3-V supply
Supply extended voltage range for RF blocks (AVDD3/5) – 5-V supply
Operating temperature range
Digital I/O voltage with respect to DVSS
Analog I/O voltage with respect to AVSS
Difference between any AVDD or DVDD
MIN
2.7
2.7
4.75
– 25
– 0.3
– 0.3
NOM
MAX
3.0
3.3
3.0
3.3
5.0
5.25
85
DVDD + 0.3
AVDD + 0.3
0.3
UNIT
Vdc
Vdc
Vdc
°C
Vdc
V
V
2.3 Electrical Characteristics Over Recommended Operating Free-Air
Temperature Range (Unless Otherwise Noted)
2.3.1 Digital Inputs And Outputs
PARAMETER
Low-level output current with digital pad lower than 0.1 V (CMOS)
Low-level output current with digital pad lower than 0.4 V (TTL)
High-level output current with digital pad higher than VDD – 0.1 V
(CMOS)
High-level output current with digital pad higher than VDD – 0.4 V (TTL)
Minimum high-level input voltage, VIH
Maximum low-level input voltage, VIL
Output current on high-impedance state outputs
Input current (any input) when input high
Input current (standard inputs) when input low
Input current (inputs with pullup TMS, TDI, TEST1, TEST2) when input
low
MIN
0
0
– 40
–1
VDD – 0.3
– 15
–1
TYP MAX
40
1
0
0
VSS + 0.3
+15
1
15
UNIT
µA
mA
µA
mA
V
V
µA
µA
µA
µA
2–1