CC2510_15 Datasheet, PDF (9/245 Pages) Texas Instruments – Low-Power SoC (System-on-Chip) with MCU, Memory,2.4 GHz RF Transceiver, and USB Controller

CC2511F8 - Not Recommended for New Designs
CC2510Fx / CC2511Fx
4 Operating Conditions
4.1 CC2510Fx Operating Conditions
The operating conditions for CC2510Fx are listed in Table 3 below.
Parameter
Min
Max
Operating ambient temperature, TA −40
85
Operating supply voltage (VDD)
2.0
3.6
Unit Condition
°C
V All supply pins must have the same voltage
Table 3: Operating Conditions for CC2510Fx
4.2 CC2511Fx Operating Conditions
The operating conditions for CC2511Fx are listed in Table 4 below.
Parameter
Min
Max
Operating ambient temperature, TA 0
85
Operating supply voltage (VDD)
3.0
3.6
Unit Condition
°C
V All supply pins must have the same voltage
Table 4: Operating Conditions for CC2511Fx
5 General Characteristics
T_A = 25°C, VDD = 3.0 V if nothing else stated
Parameter
Min
Typ
Max
Unit
Radio part
Frequency range 2400
2483.5
MHz
Data rate
1.2
1.2
26
500
kBaud
250
kBaud
500
kBaud
Wake-Up Timing
PM1  Active
4
µs
Mode
PM2/3 Active
100
µs
Mode
Condition/Note
There will be spurious signals at n/2·crystal oscillator
frequency (n is an integer number). RF frequencies at
n/2·crystal oscillator frequency should therefore be
avoided (e.g. 2405, 2418, 2431, 2444, 2457, 2470 and
2483 MHz when using a 26 MHz crystal).
2-FSK
GFSK
(Shaped) MSK (also known as differential offset QPSK)
Optional Manchester encoding (the data rate in kbps will
be half the baud rate)
Digital regulator on. HS RCOSC and high speed crystal
oscillator off. 32.768 kHz XOSC or low power RCOSC
running.
SLEEP.OSC_PD=1 and CLKCON.OSC=1
Digital regulator off. HS RCOSC and high speed crystal
oscillator off. 32.768 kHz XOSC or low power RCOSC
running (PM2). No crystal oscillators or RC oscillators
are running in PM3.
SLEEP.OSC_PD=1 and CLKCON.OSC=1
Table 5: General Characteristics
SWRS055G
Page 9 of 236