CC2510_15 Datasheet, PDF (164/245 Pages) Texas Instruments – Low-Power SoC (System-on-Chip) with MCU, Memory,2.4 GHz RF Transceiver, and USB Controller

CC2511F8 - Not Recommended for New Designs
CC2510Fx / CC2511Fx
0xDF40: I2SCFG0 - I²S Configuration Register 0
Bit Field Name Reset R/W Description
7 TXIEN
0
6 RXIEN
0
5 ULAWE
0
4 ULAWC
0
3 TXMONO 0
2 RXMONO 0
1 MASTER 0
0 ENAB
0
R/W Transmit interrupt enable
0 Interrupt disabled
1 Interrupt enabled
R/W Receive interrupt enable
0 Interrupt disabled
1 Interrupt enabled
R/W µ-Law expansion enable
0 Expansion disabled
1 Expansion enabled
ENAB=0 Expand data written to I2SDATH
ENAB=1 Enable expansion of data to transmit
R/W µ-Law compression enable
0 Compression disabled
1 Compression enabled
ENAB=0 Compress data written to I2SDATH:I2SDATL
ENAB=1 Enable compression of data received
R/W TX mono enable
0 Stereo mode
1 Each sample of audio data will be repeated in both channels before a new sample is
fetched. This is to enable sending a mono signal to a stereo audio sink device.
R/W RX mono enable
0 Stereo mode
1 Data from the right channel will be discarded, i.e. not be read into the data registers.
This feature is included because some mono devices repeat their audio data in both
channels and left is the default mono channel.
R/W Master mode enable
0 Slave (CLK and WS are read from the pads)
1 Master (generate the CLK and WS)
R/W I²S interface enable
0 Disable (I²S can be used as a µ-Law compression/expansion unit)
1 Enable
SWRS055G
Page 164 of 236