CC2510_15 Datasheet, PDF (24/245 Pages) Texas Instruments – Low-Power SoC (System-on-Chip) with MCU, Memory,2.4 GHz RF Transceiver, and USB Controller

CC2511F8 - Not Recommended for New Designs
CC2510Fx / CC2511Fx
6.13 Debug Interface AC Characteristics
T_A = 25°C, VDD = 3.0 V if nothing else stated. All measurement results are obtained using the
CC2510EM reference designs ([1]).
Parameter
Min
Typ
Max Unit Condition/Note
Debug clock period
125
Debug data setup
5
Debug data hold
5
Clock to data delay
RESET_N inactive
10
after P2_2 rising
ns See item 1, Figure 6
Note: CLKCON.CLKSPD must be 000 or 001 when using the
debug interface
ns See item 2, Figure 6
ns See item 3, Figure 6
10 ns See item 4, Figure 6, load = 10 pF
ns See item 5, Figure 6
Table 21: Debug Interface AC Characteristics
DEBUG CLK
P2_2
2
DEBUG DATA
P2_1
DEBUG DATA
P2_1
1
3
4
RESET_N
5
Figure 6: Debug Interface AC Characteristics
6.14 Port Outputs AC Characteristics
T_A = 25°C, VDD = 3.0 V if nothing else stated. All measurement results are obtained using the
CC2510EM reference designs ([1]).
Parameter
Min
Typ
Max Unit Condition/Note
P0_[0:7], P1_[2:7],
P2_[0:4] Port output
rise time
(IOCFG1.GDO_DS=0 /
IOCFG1.GDO_DS=1)
P0_[0:7], P1_[2:7],
P2_[0:4] Port output
fall time
(IOCFG1.GDO_DS=0 /
IOCFG1.GDO_DS=1)
3.15 / 1.34
3.2 / 1.44
ns Load = 10 pF
Timing is with respect to 10% VDD and 90% VDD levels.
Values are estimated
ns Load = 10 pF
Timing is with respect to 90% VDD and 10% VDD.
Values are estimated
Table 22: Port Outputs AC Characteristics
SWRS055G
Page 24 of 236