CC2510_15 Datasheet, PDF (63/245 Pages) Texas Instruments – Low-Power SoC (System-on-Chip) with MCU, Memory,2.4 GHz RF Transceiver, and USB Controller

CC2511F8 - Not Recommended for New Designs
CC2510Fx / CC2511Fx
S0CON (0x98) - CPU Interrupt Flag 2
Bit Field Name Reset R/W Description
7:2
0
R/W Not used
1 _{ENCIF_1} 0
0 _{ENCIF_0} 0
R/W AES interrupt. ENCIF has two interrupt flags, ENCIF_1 and ENCIF_0. Interrupt
source sets both ENCIF_1 and ENCIF_0, but setting one of these flags in SW will
generate an interrupt request. Both flags are set when the AES co-processor
requests the interrupt.
0 Interrupt not pending
1 Interrupt pending
R/W AES interrupt. ENCIF has two interrupt flags, ENCIF_1 and ENCIF_0. Interrupt
source sets both ENCIF_1 and ENCIF_0, but setting one of these flags in SW will
generate an interrupt request. Both flags are set when the AES co-processor
requests the interrupt.
0 Interrupt not pending
1 Interrupt pending
S1CON (0x9B) - CPU Interrupt Flag 3
Bit Field Name Reset R/W Description
7:6
0
R/W Not used
1 _{RFIF_1} 0
0 _{RFIF_0} 0
R/W RF general interrupt. RFIF has two interrupt flags, RFIF_1 and RFIF_0. Interrupt
source sets both RFIF_1 and RFIF_0, but setting one of these flags in SW will
generate an interrupt request. Both flags are set when the radio requests the
interrupt.
0 Interrupt not pending
1 Interrupt pending
R/W RF general interrupt. RFIF has two interrupt flags, RFIF_1 and RFIF_0. Interrupt
source sets both RFIF_1 and RFIF_0, but setting one of these flags in SW will
generate an interrupt request. Both flags are set when the radio requests the
interrupt.
0 Interrupt not pending
1 Interrupt pending
SWRS055G
Page 63 of 236