PIC18FXX20 Datasheet, PDF (76/366 Pages) Microchip Technology – 64/80-Pin High Performance 1 Mbit Enhanced FLASH Microcontrollers with A/D

PIC18FXX20
6.2.2 16-BIT WORD WRITE MODE
Figure 6-2 shows an example of 16-bit Word Write
mode for PIC18F8X20 devices. This mode is used for
word-wide memories, which includes some of the
EPROM and FLASH type memories. This mode allows
opcode fetches and Table Reads from all forms of
16-bit memory, and Table Writes to any type of
word-wide external memories. This method makes a
distinction between TBLWT cycles to even or odd
addresses.
During a TBLWT cycle to an even address
(TBLPTR<0> = 0), the TABLAT data is transferred to a
holding latch and the external address data bus is
tri-stated for the data portion of the bus cycle. No write
signals are activated.
During a TBLWT cycle to an odd address
(TBLPTR<0> = 1), the TABLAT data is presented on
the upper byte of the AD15:AD0 bus. The contents of
the holding latch are presented on the lower byte of the
AD15:AD0 bus.
The WRH signal is strobed for each write cycle; the
WRL pin is unused. The signal on the BA0 pin indicates
the LSbit of TBLPTR, but it is left unconnected. Instead,
the UB and LB signals are active to select both bytes.
The obvious limitation to this method is that the Table
Write must be done in pairs on a specific word
boundary to correctly write a word location.
FIGURE 6-2:
16-BIT WORD WRITE MODE EXAMPLE
PIC18F8X20
AD<7:0>
AD<15:8>
ALE
A<19:16>
CE
OE
WRH
373
A<20:1>
A<x:0> ^{JEDEC Word}
EPROM Memory
D<15:0>
D<15:0>
CE OE WR⁽¹⁾
373
Address Bus
Data Bus
Control Lines
Note 1: This signal only applies to Table Writes. See Section 5.1 (Table Reads and Writes).
DS39609A-page 74
Advance Information
 2003 Microchip Technology Inc.