English
Language : 

PIC18F2682 Datasheet, PDF (54/484 Pages) Microchip Technology – 28/40/44-Pin Enhanced Flash Microcontrollers with ECAN Technology, 10-Bit A/D and nanoWatt Technology
PIC18F2682/2685/4682/4685
TABLE 4-4: INITIALIZATION CONDITIONS FOR ALL REGISTERS (CONTINUED)
Register
Applicable Devices
Power-on Reset,
Brown-out Reset
PIR2
2682 2685 4682 4685
2682 2685 4682 4685
00-0 0000
0--0 000-
MCLR Resets,
WDT Reset,
RESET Instruction,
Stack Resets
00-0 0000
0--0 000-
Wake-up via WDT
or Interrupt
uu-u uuuu(1)
u--u uuu-(1)
PIE2
2682 2685 4682 4685 00-0 0000
00-0 0000
uu-u uuuu
2682 2685 4682 4685 0--0 000-
0--0 000-
u--u uuu-
IPR1
2682 2685 4682 4685 1111 1111
1111 1111
uuuu uuuu
PIR1
2682 2685 4682 4685
2682 2685 4682 4685
-111 1111
0000 0000
-111 1111
0000 0000
-uuu uuuu
uuuu uuuu(1)
2682 2685 4682 4685 -000 0000
-000 0000
-uuu uuuu
PIE1
2682 2685 4682 4685 0000 0000
0000 0000
uuuu uuuu
2682 2685 4682 4685 -000 0000
-000 0000
-uuu uuuu
OSCTUNE 2682 2685 4682 4685 0q-0 0000
0q-0 0000
uu-u uuuu
TRISE
2682 2685 4682 4685 0000 -111
0000 -111
uuuu -uuu
TRISD
2682 2685 4682 4685 1111 1111
1111 1111
uuuu uuuu
TRISC
2682 2685 4682 4685 1111 1111
1111 1111
uuuu uuuu
TRISB
TRISA(5)
2682 2685 4682 4685
2682 2685 4682 4685
1111 1111
1111 1111(5)
1111 1111
1111 1111(5)
uuuu uuuu
uuuu uuuu(5)
LATE
2682 2685 4682 4685 ---- -xxx
---- -uuu
---- -uuu
LATD
2682 2685 4682 4685 xxxx xxxx
uuuu uuuu
uuuu uuuu
LATC
2682 2685 4682 4685 xxxx xxxx
uuuu uuuu
uuuu uuuu
LATB
LATA(5)
2682 2685 4682 4685
2682 2685 4682 4685
xxxx xxxx
xxxx xxxx(5)
uuuu uuuu
uuuu uuuu(5)
uuuu uuuu
uuuu uuuu(5)
PORTE
2682 2685 4682 4685 ---- x000
---- x000
---- uuuu
PORTD
2682 2685 4682 4685 xxxx xxxx
uuuu uuuu
uuuu uuuu
PORTC
2682 2685 4682 4685 xxxx xxxx
uuuu uuuu
uuuu uuuu
PORTB
PORTA(5)
2682 2685 4682 4685
2682 2685 4682 4685
xxxx xxxx
xx0x 0000(5)
uuuu uuuu
uu0u 0000(5)
uuuu uuuu
uuuu uuuu(5)
ECANCON 2682 2685 4682 4685 0001 0000
0001 0000
uuuu uuuu
TXERRCNT 2682 2685 4682 4685 0000 0000
0000 0000
uuuu uuuu
RXERRCNT 2682 2685 4682 4685 0000 0000
0000 0000
uuuu uuuu
COMSTAT 2682 2685 4682 4685 0000 0000
0000 0000
uuuu uuuu
CIOCON
2682 2685 4682 4685 --00 ----
--00 ----
--uu ----
Legend: u = unchanged, x = unknown, - = unimplemented bit, read as ‘0’, q = value depends on condition.
Shaded cells indicate conditions do not apply for the designated device.
Note 1: One or more bits in the INTCONx or PIRx registers will be affected (to cause wake-up).
2: When the wake-up is due to an interrupt and the GIEL or GIEH bit is set, the PC is loaded with the interrupt
vector (0008h or 0018h).
3: When the wake-up is due to an interrupt and the GIEL or GIEH bit is set, the TOSU, TOSH and TOSL are
updated with the current value of the PC. The STKPTR is modified to point to the next location in the
hardware stack.
4: See Table 4-3 for Reset value for specific condition.
5: Bits 6 and 7 of PORTA, LATA and TRISA are enabled depending on the oscillator mode selected. When
not enabled as PORTA pins, they are disabled and read ‘0’.
6: This register reads all ‘0’s until the ECAN™ technology is set up in Mode 1 or Mode 2.
DS39761B-page 52
Preliminary
© 2007 Microchip Technology Inc.