PIC16LF1824T39A_12 Datasheet, PDF (44/418 Pages) Microchip Technology – 20-Pin Flash Microcontrollers with XLP Technology

PIC16LF1824T39A
REGISTER 4-1:
CONFIGURATION WORD 1
R/P-1/1
FCMEN
bit 13
R/P-1/1
IESO
R/P-1/1
CLKOUTEN
R/P-1/1
R/P-1/1
BOREN<1:0>
R/P-1/1
CPD
bit 8
R/P-1/1
CP
bit 7
R/P-1/1
MCLRE
R/P-1/1
PWRTE
R/P-1/1
R/P-1/1
WDTE<1:0>
R/P-1/1
R/P-1/1
FOSC<2:0>
R/P-1/1
bit 0
Legend:
R = Readable bit
‘0’ = Bit is cleared
P = Programmable bit
‘1’ = Bit is set
U = Unimplemented bit, read as ‘1’
-n = Value when blank or after Bulk Erase
bit 13
bit 12
bit 11
bit 10-9
bit 8
bit 7
bit 6
bit 5
bit 4-3
FCMEN: Fail-Safe Clock Monitor Enable bit
1 = Fail-Safe Clock Monitor is enabled
0 = Fail-Safe Clock Monitor is disabled
IESO: Internal External Switchover bit
1 = Internal/External Switchover mode is enabled
0 = Internal/External Switchover mode is disabled
CLKOUTEN: Clock Out Enable bit
If FOSC Configuration bits are set to LP, XT, HS modes:
This bit is ignored, CLKOUT function is disabled. Oscillator function on the CLKOUT pin.
All other FOSC modes:
1 = CLKOUT function is disabled. I/O function on the CLKOUT pin.
0 = CLKOUT function is enabled on the CLKOUT pin
BOREN<1:0>: Brown-out Reset Enable bits⁽¹⁾
11 = BOR enabled
10 = BOR enabled during operation and disabled in Sleep
01 = BOR controlled by SBOREN bit of the BORCON register
00 = BOR disabled
CPD: Data Code Protection bit⁽²⁾
1 = Data memory code protection is disabled
0 = Data memory code protection is enabled
CP: Code Protection bit⁽³⁾
1 = Program memory code protection is disabled
0 = Program memory code protection is enabled
MCLRE: RA3/MCLR/VPP Pin Function Select bit
If LVP bit = 1:
This bit is ignored.
If LVP bit = 0:
1 = MCLR/VPP pin function is MCLR; Weak pull-up enabled.
0 = MCLR/VPP pin function is digital input; MCLR internally disabled; Weak pull-up under control of WPUA register.
PWRTE: Power-up Timer Enable bit⁽¹⁾
1 = PWRT disabled
0 = PWRT enabled
WDTE<1:0>: Watchdog Timer Enable bit
11 = WDT enabled
10 = WDT enabled while running and disabled in Sleep
01 = WDT controlled by the SWDTEN bit in the WDTCON register
00 = WDT disabled
Note 1:
2:
3:
Enabling Brown-out Reset does not automatically enable Power-up Timer.
The entire data EEPROM will be erased when the code protection is turned off during an erase.
The entire program memory will be erased when the code protection is turned off.
DS41657A-page 44
Preliminary
 2012 Microchip Technology Inc.