PIC18F6520-I Datasheet, PDF (318/380 Pages) Micrel Semiconductor – 64/80-Pin High-Performance, 256 Kbit to 1 Mbit Enhanced Flash Microcontrollers with A/D

PIC18F6520/8520/6620/8620/6720/8720
26.3 DC Characteristics: PIC18F6520/8520/6620/8620/6720/8720 (Industrial, Extended)
PIC18LF6520/8520/6620/8620/6720/8720 (Industrial) (Continued)
DC CHARACTERISTICS
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40°C ≤ TA ≤ +85°C for industrial
-40°C ≤ TA ≤ +125°C for extended
Param
No.
Sym
Characteristic
Min
Max Units
Conditions
VOL Output Low Voltage
D080
I/O ports
D080A
D083
D083A
OSC2/CLKO
(RC mode)
VOH Output High Voltage⁽³⁾
D090
I/O ports
D090A
—
—
—
—
VDD – 0.7
VDD – 0.7
0.6
V IOL = 8.5 mA, VDD = 4.5V,
-40°C to +85°C
0.6
V IOL = 7.0 mA, VDD = 4.5V,
-40°C to +125°C
0.6
V IOL = 1.6 mA, VDD = 4.5V,
-40°C to +85°C
0.6
V IOL = 1.2 mA, VDD = 4.5V,
-40°C to +125°C
—
V IOH = -3.0 mA, VDD = 4.5V,
-40°C to +85°C
—
V IOH = -2.5 mA, VDD = 4.5V,
-40°C to +125°C
D092
D092A
OSC2/CLKO
(RC mode)
D150 VOD Open-Drain High Voltage
Capacitive Loading Specs
on Output Pins
VDD – 0.7
VDD – 0.7
—
—
V IOH = -1.3 mA, VDD = 4.5V,
-40°C to +85°C
—
V IOH = -1.0 mA, VDD = 4.5V,
-40°C to +125°C
8.5
V RA4 pin
D100^{(4) COSC2 OSC2 pin}
—
15
pF In XT, HS and LP modes
when external clock is used
to drive OSC1
D101 CIO
D102 CB
All I/O pins and OSC2
(in RC mode)
SCL, SDA
—
50
pF To meet the AC Timing
Specifications
—
400
pF In I²C mode
Note 1: In RC oscillator configuration, the OSC1/CLKI pin is a Schmitt Trigger input. It is not recommended that the
PICmicro device be driven with an external clock while in RC mode.
2: The leakage current on the MCLR pin is strongly dependent on the applied voltage level. The specified
levels represent normal operating conditions. Higher leakage current may be measured at different input
voltages.
3: Negative current is defined as current sourced by the pin.
4: Parameter is characterized but not tested.
DS39609B-page 316
 2004 Microchip Technology Inc.