MC908GR8CDWE Datasheet, PDF (305/408 Pages) Freescale Semiconductor, Inc – M68HC08 Microcontrollers

Freescale Semiconductor, Inc.
Serial Peripheral Interface (SPI)
Transmission Formats
SPSCK CYCLE #
FOR REFERENCE
SPSCK; CPOL = 0
1
2
3
4
5
6
7
8
SPSCK; CPOL =1
MOSI
FROM MASTER
MISO
FROM SLAVE
SS; TO SLAVE
CAPTURE STROBE
MSB BIT 6 BIT 5 BIT 4 BIT 3 BIT 2 BIT 1 LSB
MSB
BIT 6 BIT 5 BIT 4 BIT 3 BIT 2 BIT 1 LSB
Figure 20-4. Transmission Format (CPHA = 0)
MISO/MOSI
MASTER SS
SLAVE SS
CPHA = 0
SLAVE SS
CPHA = 1
BYTE 1
BYTE 2
BYTE 3
Figure 20-5. CPHA/SS Timing
When CPHA = 0 for a slave, the falling edge of SS indicates the
beginning of the transmission. This causes the SPI to leave its idle state
and begin driving the MISO pin with the MSB of its data. Once the
transmission begins, no new data is allowed into the shift register from
the transmit data register. Therefore, the SPI data register of the slave
must be loaded with transmit data before the falling edge of SS. Any data
written after the falling edge is stored in the transmit data register and
transferred to the shift register after the current transmission.
20.6.3 Transmission Format When CPHA = 1
Figure 20-6 shows an SPI transmission in which CPHA is logic 1. The
figure should not be used as a replacement for data sheet parametric
information. Two waveforms are shown for SPSCK: one for CPOL = 0
and another for CPOL = 1. The diagram may be interpreted as a master
or slave timing diagram since the serial clock (SPSCK), master in/slave
MC68HC908GR8 — Rev 4.0
MOTOROLA
Serial Peripheral Interface (SPI)
For More Information On This Product,
Go to: www.freescale.com
Technical Data
305