MC908GR8CDWE Datasheet, PDF (285/408 Pages) Freescale Semiconductor, Inc – M68HC08 Microcontrollers

Freescale Semiconductor, Inc.
System Integration Module (SIM)
Exception Control
condition code register) and if the corresponding interrupt enable bit is
set, the SIM proceeds with interrupt processing; otherwise, the next
instruction is fetched and executed.
If more than one interrupt is pending at the end of an instruction
execution, the highest priority interrupt is serviced first. Figure 19-11
demonstrates what happens when two interrupts are pending. If an
interrupt is pending upon exit from the original interrupt service routine,
the pending interrupt is serviced before the LDA instruction is executed.
CLI
LDA #$FF
BACKGROUND
ROUTINE
INT1
PSHH
PULH
RTI
INT1 INTERRUPT SERVICE ROUTINE
INT2
PSHH
PULH
RTI
INT2 INTERRUPT SERVICE ROUTINE
Figure 19-11. Interrupt Recognition Example
The LDA opcode is prefetched by both the INT1 and INT2 RTI
instructions. However, in the case of the INT1 RTI prefetch, this is a
redundant operation.
NOTE:
To maintain compatibility with the M6805 Family, the H register is not
pushed on the stack during interrupt entry. If the interrupt service routine
modifies the H register or uses the indexed addressing mode, software
should save the H register and then restore it prior to exiting the routine.
MC68HC908GR8 — Rev 4.0
MOTOROLA
System Integration Module (SIM)
For More Information On This Product,
Go to: www.freescale.com
Technical Data
285