MC908GR8CDWE Datasheet, PDF (160/408 Pages) Freescale Semiconductor, Inc – M68HC08 Microcontrollers

Flash Memory
Freescale Semiconductor, Inc.
PGM — Program Control Bit
This read/write bit configures the memory for program operation.
PGM is interlocked with the ERASE bit such that both bits cannot be
equal to 1 or set to 1 at the same time.
1 = Program operation selected
0 = Program operation unselected
11.5 FLASH Page Erase Operation
Use this step-by-step procedure to erase a page (64 bytes) of FLASH
memory to read as logic 1:
1. Set the ERASE bit, and clear the MASS bit in the FLASH control
register.
2. Read the FLASH block protect register.
3. Write any data to any FLASH address within the page address
range desired.
4. Wait for a time, t_nvs (min. 10µs)
5. Set the HVEN bit.
6. Wait for a time, t_Erase (min. 1ms)
7. Clear the ERASE bit.
8. Wait for a time, t_nvh (min. 5µs)
9. Clear the HVEN bit.
10. After a time, t_rcv (typ. 1µs), the memory can be accessed again in
read mode.
NOTE: While these operations must be performed in the order shown, other
unrelated operations may occur between the steps.
Technical Data
160
MC68HC908GR8 — Rev 4.0
Flash Memory
For More Information On This Product,
Go to: www.freescale.com
MOTOROLA