|
M0564LE4AE Datasheet, PDF (13/161 Pages) List of Unclassifed Manufacturers – 32-BIT MICROCONTROLLER | |||
|
◁ |
M0564
ï® Supports 16-bit resolution PWM counter, each timer provides 1 PWM counter
ï® Supports up, down and up/down counter operation type
ï® Supports one-shot or Auto-reload counter operation mode
ï® Supports mask function and tri-state enable for each PWM pin
ï® Supports brake function
ï® Supports interrupt when PWM counter match zero, period value or compared
value, and brake condition happened
ï® Supports trigger ADC when PWM counter match zero, period value or compared
value
ï¬Watchdog Timer
â Supports multiple clock sources from LIRC(default selection), HCLK/2048 and LXT
8 selectable time-out period from 1.6ms ~ 26.0sec (depending on clock source)
â Able to wake up from Power-down or Idle mode
â Interrupt or reset selectable on watchdog time-out
ï¬Window Watchdog Timer
â
â
ï¬ RTC
Supports multiple clock sources from HCLK/2048 (default selection) and LIRC
Window set by 6-bit counter with 11-bit prescale
Interrupt or reset selectable on time-out
â Supports separate battery power pin VBAT
â Supports software compensation by setting frequency compensate register (FCR)
â Supports RTC counter (second, minute, hour) and calendar counter (day, month, year)
â Supports Alarm registers (second, minute, hour, day, month, year)
â Supports Alarm mask registers
â Selectable 12-hour or 24-hour mode
â Automatic leap year recognition
â Supports periodic time tick interrupt with 8 period options 1/128, 1/64, 1/32, 1/16, 1/8,
1/4, 1/2 and 1 second
â Supports wake-up function
ï· PWM
â Supports maximum clock frequency up to144MHz
â Supports up to two PWM modules, each module provides 6 output channels.
â Supports independent mode for PWM output/Capture input channel
â Supports complementary mode for 2 complementary paired PWM output channel
ï® Dead-time insertion with 12-bit resolution
ï® Two compared values during one period
â Supports 12-bit pre-scalar from 1 to 4096
â Supports 16-bit resolution PWM counter
ï® Up, down and up/down counter operation type
â Supports mask function and tri-state enable for each PWM pin
â Supports brake function
ï® Brake source from pin and system safety events: clock failed, Brown-out
detection and CPU lockup.
ï® Noise filter for brake source from pin
ï® Edge detect brake source to control brake state until brake interrupt cleared
ï® Level detect brake source to auto recover function after brake condition removed
â Supports interrupt on the following events:
ï® PWM counter match zero, period value or compared value
ï® Brake condition happened
â Supports trigger ADC on the following events:
May 05, 2017
Page 13 of 161
Rev 1.00
|
▷ |