AMIS-53050 Datasheet, PDF (72/107 Pages) AMI SEMICONDUCTOR – Frequency Agile Transceiver

AMIS-53050 Frequency Agile Transceiver
Data Sheet
6.7.3. Burst Transmit Data
Table 59: Burst Transmission Configuration
Register
Number (HEX) Name
Bits
0X10
Idle Config
1
Function
Enable burst transmissions
Burst mode of transmission is a function that can cause the AMIS-53050 to transmit a message at a programmed time interval or by
asserting the xBURST pin to active (the AMIS-53050 must be in the xBURST mode), causing the AMIS-53050 to immediately transmit
a message. The burst mode can also be started by enabling the burst mode in the idle register and then writing to the command
register to set the AMIS-53050 into idle mode. The xBURST mode sets a timed automatic transmission of register values (a message)
or ADC conversion values.
Register descriptions:
Burst Config- Set the burst transmission parameters
Burst Interval- Set the time interval between burst transmissions
User DataA- Message for timer initiated transmissions
User DataB- Message for xBURST initiated transmissions.
Figure 41: Data Packet Format Showing Order for Burst TX Content
AMI Semiconductor – Jan. 07, M-20639-002
72
www.amis.com