XC2V4000 Datasheet, PDF (51/311 Pages) Xilinx, Inc – Summary of Features

R
Virtex™-II Platform FPGAs: DC and Switching Characteristics
Table 4: Quiescent Supply Current
Symbol
Description
Device
Min
Typical
Max Units
Quiescent V_CCINT supply current
I_CCINTQ
Quiescent V_CCO supply current^(1,2)
I_CCOQ
XC2V40
XC2V80
XC2V250
XC2V500
XC2V1000
XC2V1500
XC2V2000
XC2V3000
XC2V4000
XC2V6000
XC2V8000
XC2V40
XC2V80
XC2V250
XC2V500
XC2V1000
XC2V1500
XC2V2000
XC2V3000
XC2V4000
XC2V6000
XC2V8000
50
TBD
50
125
65
150
80
200
100
250
125
350
mA
150
400
200
500
225
650
250
800
300
1100
1
TBD
1
2
1
2
1
2
1
2
2
4
mA
2
4
2
4
2
4
2
4
2
4
Quiescent V_CCAUX supply current^(1,2)
I_CCAUXQ
XC2V40
XC2V80
XC2V250
XC2V500
XC2V1000
XC2V1500
XC2V2000
XC2V3000
XC2V4000
XC2V6000
XC2V8000
10
TBD
10
25
10
25
10
25
10
25
15
50
mA
15
50
20
75
20
75
25
100
25
100
Notes:
1. With no output current loads, no active input pull-up resistors, all I/O pins are 3-state and floating.
2. If DCI or differential signaling is used, more accurate values can be obtained by using the Power Estimator or XPOWER™.
3. Data are retained even if V_CCO drops to 0 V.
4. Values specified for quiescent supply current parameters are Commercial Grade. For Industrial Grade values, multiply Commercial
Grade values by 1.25.
Power-On Power Supply Requirements
Xilinx FPGAs require a certain amount of supply current
during power-on to insure proper device operation. The
actual current consumed depends on the power-on ramp
rate of the power supply.
The V_CCINT, V_CCAUX, and V_CCO power supplies shall each
ramp on no faster than 200 µs and no slower than 50 ms.
Ramp on is defined as: 0 V_DC to minimum supply voltages.
Table 5 shows the minimum current required by Virtex-II
devices for proper power on and configuration.
Power supplies can be turned on in any sequence.
If any V_CCO bank powers up before V_CCAUX, then each bank
draws up to 300 mA, worst case, until the V_CCAUX powers
on⁽¹⁾. This does not harm the device. If the current is limited
to the minimum value above, or larger, the device powers on
properly after all three supplies have passed through their
power on reset threshold voltages.
Once initialized and configured, use the power calculator to
estimate current drain on these supplies.
Notes:
1. The 300 mA is transient current (peak); it eventually
disappears even if V_CCAUX does not power up.
DS031-3 (v3.0) August 1, 2003
Product Specification
www.xilinx.com
1-800-255-7778
Module 3 of 4
3