SM320C6727B-EP Datasheet, PDF (34/109 Pages) Texas Instruments – Floating-Point Digital Signal Processor

SM320C6727B-EP
SPRS793A – SEPTEMBER 2011 – REVISED OCTOBER 2011
100000000.00
www.ti.com
10000000.00
1000000.00
100000.00
` _{Wirebond Voiding Fail Mode}
10000.00
1000.00
80
90
100
110
120
130
140
150
160
170
180
Continuous Tj (°C)
(1) See the absolute maximum ratings and the recommended operating conditions.
Figure 4-2. SM320C6727B-EP Wirebond Voiding Fail Mode
4.5 Parameter Information
4.5.1 Parameter Information Device-Specific Information
Tester Pin Electronics
Data Sheet Timing Reference Point
42 Ω
4.0 pF
3.5 nH
1.85 pF
Transmission Line
Z0 = 50 Ω
(see note)
Output
Under
Test
Device Pin
(see note)
A. The data sheet provides timing at the device pin. For output timing analysis, the tester pin electronics and its
transmission line effects must be taken into account. A transmission line with a delay of 2 ns or longer can be used to
produce the desired transmission line effect. The transmission line is intended as a load only. It is not neccessary to
add or subtract the transmission line delay (2 ns or longer) from the data sheet timings.
Input requirements in this data sheet are tested with an input slew rate of < 4 Volts per nanosecond (4 V/ns) at the
device pin.
Figure 4-3. Test Load Circuit for AC Timing Measurements
34
Peripheral and Electrical Specifications
Copyright © 2011, Texas Instruments Incorporated
Submit Documentation Feedback
Product Folder Link(s): SM320C6727B-EP