CC2430 Datasheet, PDF (220/234 Pages) Texas Instruments – A True System-on-Chip solution for 2.4 GHz IEEE 802.15.4 / ZigBee-TM

CC2430
Bit Name
Reset R/W Description
7:0 RXFIFOCNT[7:0]
0x00
R
Number of bytes in the RX FIFO
Table 97: Register RXFIFOCNT (0xDF53)
Bit Name
Reset R/W Description
7:6 -
00
5
ABORTRX_ON_SRXON
1
4
RX_INTERRUPTED
0
3
AUTO_TX2RX_OFF
0
2
RX2RX_TIME_OFF
0
1
PENDING_OR
0
0
ACCEPT_ACKPKT.
1
R0
R/W
R
R/W
R/W
R/W
R/W
Reserved, read as 0.
Abort RX when SRXON strobe is issued
0 : Packet reception is not aborted when SRXON is issued
1 : Packet reception is aborted when SRXON is issued
RX interrupted by strobe command
This bit is cleared when the next strobe is detected.
0 : Strobe command detected
1 : Packet reception was interrupted by strobe command
Automatically go to RX after TX. Applies to both data
packets and ACK packets.
0 : Automatic RX after TX
1 : No automatic RX after TX
Turns off the 12 symbol timeout after packet reception has
ended. Active high.
This bit is OR’ed with the pending bit from FFCTRL before it
goes to the modulator.
Accept ACK packet control.
0 : Reject all ACK packets
1 : ACK packets are received
Table 98: Register FSMTC1 (0xDF54)
Bit Name
7:0 VERSION[7:0]
Reset
0x01
R/W
R
Description
Chip revision number
Table 99: Register CHVER (0xDF60)
Bit Name
7:0 CHIPID[7:0]
Reset
0x85
R/W
R
Description
Chip identification number. Always read as 0x85.
Table 100: Register CHIPID (0xDF61)
CC2430 PRELIMINARY Data Sheet (rev. 1.03) SWRS036A
Page 220 of 232