CC2430 Datasheet, PDF (199/234 Pages) Texas Instruments – A True System-on-Chip solution for 2.4 GHz IEEE 802.15.4 / ZigBee-TM

CC2430
14.34.8.23 SACKPEND
Function:
Send acknowledge frame
with pending field set
Description: The
SACKPEND
instruction sends an acknowledge frame
with pending field set. The instruction
waits for the radio to acknowledge the
command before executing the next
instruction.
Operation: SACKPEND
Opcode:
76543210
11001001
14.34.8.24 ISSTOP
Function:
Stop program execution
Description: The ISSTOP instruction
stops the CSP program execution. The
instruction memory is cleared, any loop
start location set be the LABEL instruction
is invalidated and the IRQ_CSP_STOP
interrupt flag is asserted.
Operation: Stop execution
Opcode:
76543210
11111111
14.34.8.25 ISSTART
Function:
Start program execution
Description: The ISSTART instruction
starts the CSP program execution from
first instruction written to instruction
memory.
Operation: PC := 0, start execution
Opcode:
76543210
11111110
14.34.8.26 ISTXCALN
Function:
Enable and calibrate
frequency synthesizer for TX.
Note this instruction is for test purposes
only (see section 14.20).
Description: The ISTXCALN instruction
immediately enables and calibrates
frequency synthesizer for TX. The
instruction waits for the radio to
acknowledge the command before
executing the next instruction.
Operation: STXCALN
Opcode:
76543210
11100001
14.34.8.27 ISRXON
Function:
Enable and calibrate
frequency synthesizer for RX
Description: The ISRXON instruction
immediately enables and calibrates
frequency synthesizer for RX. The
instruction waits for the radio to
acknowledge the command before
executing the next instruction.
Operation: SRXON
Opcode:
76543210
11100010
CC2430 PRELIMINARY Data Sheet (rev. 1.03) SWRS036A
Page 199 of 232