CC2430 Datasheet, PDF (105/234 Pages) Texas Instruments – A True System-on-Chip solution for 2.4 GHz IEEE 802.15.4 / ZigBee-TM

interrupts, the corresponding interrupt flag
must be cleared by software before a new
interrupt request is generated. Also, enabling
an interrupt mask bit will generate a new
interrupt request if the corresponding interrupt
flag is set.
13.3.11 Timer 1 DMA Triggers
There are three DMA triggers associated with
Timer 1. These are DMA triggers T1_CH0,
T1_CH1 and T1_CH2 which are generated on
timer compare events as follows:
• T1_CH0 – channel 0 compare
• T1_CH1 – channel 1 compare
• T1_CH2 – channel 2 compare
13.3.12 Timer 1 Registers
This section describes the Timer 1 registers
which consist of the following registers:
• T1CNTH – Timer 1 Count High
• T1CNTL – Timer 1 Count Low
• T1CTL – Timer 1 Control and Status
• T1CCTLx – Timer 1 Channel x
Capture/Compare Control
• T1CCxH – Timer 1 Channel x
Capture/Compare Value High
• T1CCxL – Timer 1 Channel x
Capture/Compare Value Low
CC2430
CC2430 PRELIMINARY Data Sheet (rev. 1.03) SWRS036A
Page 105 of 232