CC2430 Datasheet, PDF (197/234 Pages) Texas Instruments – A True System-on-Chip solution for 2.4 GHz IEEE 802.15.4 / ZigBee-TM

CC2430
14.34.8.13 STOP
Function:
Stop program execution
Description: The SSTOP instruction
stops the CSP program execution. The
instruction memory is cleared, any loop
start location set by the LABEL instruction
is invalidated and the IRQ_CSP_STOP
interrupt flag is asserted.
Operation: Stop execution, PC := 0,
write pointer := 0
Opcode:
76543210
11011111
14.34.8.14 SNOP
Function:
No Operation
Description: Operation continues at the
next instruction.
Operation: PC := PC+1
Opcode:
76543210
11000000
14.34.8.15 STXCALN
Function:
Enable and calibrate
frequency synthesizer for TX.
Note this instruction is for test purposes
only (see section 14.20).
Description: The STXCALN instruction
enables and calibrate frequency
synthesizer for TX. The instruction waits
for the radio to acknowledge the command
before executing the next instruction.
Operation: STXCALN
Opcode:
76543210
11000001
14.34.8.16 SRXON
Function:
Enable and calibrate
frequency synthesizer for RX
Description: The SRXON instruction
asserts the output FFCTL_SRXON_STRB
to enable and calibrate frequency
synthesizer for RX. The instruction waits
for the radio to acknowledge the command
before executing the next instruction.
Operation: SRXON
Opcode:
76543210
11000010
14.34.8.17 STXON
Function:
Enable
TX
after
calibration
Description: The STXON instruction
enables TX after calibration. The
instruction waits for the radio to
acknowledge the command before
executing the next instruction.
Operation: STXON
Opcode:
76543210
11000011
CC2430 PRELIMINARY Data Sheet (rev. 1.03) SWRS036A
Page 197 of 232