English
Language : 

CC2430 Datasheet, PDF (215/234 Pages) Texas Instruments – A True System-on-Chip solution for 2.4 GHz IEEE 802.15.4 / ZigBee-TM
CC2430
Bit Name
Reset R/W Description
7
VGA_RESET_N
6
BIAS_PD
5
BALUN_CTRL
4
RXTX
3
PRE_PD
2
PA_N_PD
1
PA_P_PD
0
DAC_LPF_PD
0
R/W The VGA_RESET_N signal is used to reset the peak
detectors in the VGA in the RX chain.
0
R/W Global Bias power down (1)
0
R/W The BALUN_CTRL signal controls whether the PA should
receive its required external biasing (1) or not (0) by
controlling the RX/TX output switch.
0
R/W RXTX signal: controls whether the LO buffers (0) or PA
buffers (1) should be used.
0
R/W Powerdown of prescaler.
0
R/W Powerdown of PA (negative path).
0
R/W Powerdown of PA (positive path). When PA_N_PD=1 and
PA_P_PD=1 the up conversion mixers are in powerdown.
0
R/W Powerdown of TX DACs.
Table 72: Register MANORH (0xDF24)
Bit Name
7
-
6
RXBPF_CAL_PD
5
CHP_PD
4
FS_PD
3
ADC_PD
2
VGA_PD
1
RXBPF_PD
0
LNAMIX_PD
Reset R/W Description
0
R0
Reserved, read as 0
0
R/W Powerdown control of complex band pass receive filter
calibration oscillator.
0
R/W Powerdown control of charge pump.
0
R/W Powerdown control of VCO, I/Q generator, LO buffers.
0
R/W Powerdown control of the ADCs.
0
R/W Powerdown control of the VGA.
0
R/W Powerdown control of complex band pass receive filter.
0
R/W Powerdown control of LNA, down conversion mixers and
front-end bias.
Table 73: Register MANORL (0xDF25)
Bit Name
Reset R/W Description
7
VGA_GAIN_OE
6:0 VGA_GAIN[6:0]
0
0x7F
R/W
R/W
Use the VGA_GAIN value during RX instead of the AGC
value.
When written, VGA manual gain override value; when read,
the currently used VGA gain setting.
Table 74: Register AGCCTRLH (0xDF26)
CC2430 PRELIMINARY Data Sheet (rev. 1.03) SWRS036A
Page 215 of 232