CC2430 Datasheet, PDF (89/212 Pages) Texas Instruments – A True System-on-Chip solution for 2.4 GHz IEEE 802.15.4 / ZigBee-TM

Peripherals : DMA Controller
CC2430
Figure 18: DMA Operation
13.5.2 DMA Configuration Parameters
Setup and control of the DMA operation is
performed by the user software. This section
describes the parameters which must be
configured before a DMA channel can be
used. Section 13.5.3 on page 92 describes
how the parameters are set up in software and
passed to the DMA controller.
The behavior of each of the five DMA channels
is configured with the following parameters:
Source address: The first address from which
the DMA channel should read data.
Destination address: The first address to
which the DMA channel should write the data
CC2430 Data Sheet (rev. 2.1) SWRS036F
Page 89 of 211