C8051F300_08 Datasheet, PDF (173/179 Pages) Silicon Laboratories – Mixed Signal ISP Flash MCU Family

C8051F300/1/2/3/4/5
17. C2 Interface
C8051F300/1/2/3/4/5 devices include an on-chip Silicon Labs 2-Wire (C2) debug interface to allow Flash
programming and in-system debugging with the production part installed in the end application. The C2
interface operates using only two pins: a bi-directional data signal (C2D) and a clock input (C2CK). See the
C2 Interface Specification for details on the C2 protocol.
17.1. C2 Interface Registers
The following describes the C2 registers necessary to perform Flash programming functions through the
C2 interface. All C2 registers are accessed through the C2 interface as described in the C2 Interface Spec-
ification.
C2 Register Definition 17.1. C2ADD: C2 Address
Reset Value
00000000
Bit7
Bit6
Bit5
Bit4
Bit3
Bit2
Bit1
Bit0
Bits7–0: The C2ADD register is accessed via the C2 interface to select the target Data register for
C2 Data Read and Data Write commands.
Address
0x00
0x01
0x02
0xB4
0x80
0xF1
0xA4
Description
Selects the Device ID register for Data Read instructions
Selects the Revision ID register for Data Read instructions
Selects the C2 Flash Programming Control register for Data
Read/Write instructions
Selects the C2 Flash Programming Data register for Data
Read/Write instructions
Selects the Port0 register for Data Read/Write instructions
Selects the Port0 Input Mode register for Data Read/Write instruc-
tions
Selects the Port0 Output Mode register for Data Read/Write
instructions
C2 Register Definition 17.2. DEVICEID: C2 Device ID
Reset Value
00000100
Bit7
Bit6
Bit5
Bit4
Bit3
Bit2
Bit1
Bit0
This read-only register returns the 8-bit device ID: 0x04 (C8051F300/1/2/3/4/5).
Rev. 2.9
173