N25Q128 Datasheet, PDF (94/185 Pages) Numonyx B.V – 128-Mbit, 1.8 V, multiple I/O, 4-Kbyte subsector erase on boot sectors, XiP enabled, serial flash memory with 108 MHz SPI bus interface

Instructions
N25Q128 - 1.8 V
S
C
DQ0
DQ1
DQ2
DQ3
9.1.15
If more than 256 bytes are sent to the device, previously latched data are discarded and the
last 256 data bytes are guaranteed to be programmed correctly within the same page. If less
than 256 data bytes are sent to device, they are correctly programmed at the requested
addresses without having any effects on the other bytes in the same page.
For optimized timings, it is recommended to use the Quad Input Fast Program (QIFP)
instruction to program all consecutive targeted bytes in a single sequence rather to using
several Quad Input Fast Program (QIFP) sequences each containing only a few bytes See
Table 33.: AC Characteristics.
Chip Select (S) must be driven High after the eighth bit of the last data byte has been
latched in, otherwise the Quad Input Fast Program (QIFP) instruction is not executed.
As soon as Chip Select (S) is driven High, the self-timed Page Program cycle (whose
duration is tPP) is initiated. While the Quad Input Fast Program (QIFP) cycle is in progress,
the Status Register may be read to check the value of the Write In Progress (WIP) bit. The
Write In Progress (WIP) bit is 1 during the self-timed Page Program cycle, and 0 when it is
completed. At some unspecified time before the cycle is completed, the Write Enable Latch
(WEL) bit is reset.
A Quad Input Fast Program (QIFP) instruction applied to a page that is protected by the
Block Protect (BP3, BP2, BP1, BP0 and TB) bits is not executed.
A Quad Input Fast Program cycle can be paused by mean of Program/Erase Suspend
(PES) instruction and resumed by mean of Program/Erase Resume (PER) instruction.
Figure 23. Quad Input Fast Program instruction sequence
0 1 2 3 4 5 6 7 8 9 10 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43
Instruction
24-bit address
Data In
1
2
Data In
3
4
Data In
5
6
23 22 21 3 2 1 0 4 0 4 0 4 0 4 0 4 0 4 0
Don’t Care
515151 515151
Don’t Care
626262 626262
Don’t Care
‘1’
737373737373
MSB MSB MSB MSB MSB MSB
Quad_Input_Fast_Program
Quad Input Extended Fast Program
The Quad Input Extended Fast Program (QIEFP) instruction is very similar to the Quad
Input Extended Fast Program (QIFP), except that the address bits are shifted in on four pins
(pin DQ0, pin DQ1, pin W/VPP/DQ2 and pin HOLD/DQ3) instead of only one.
94/185