N25Q128 Datasheet, PDF (139/185 Pages) Numonyx B.V – 128-Mbit, 1.8 V, multiple I/O, 4-Kbyte subsector erase on boot sectors, XiP enabled, serial flash memory with 108 MHz SPI bus interface

N25Q128 - 1.8 V
Instructions
9.3.5
Write Disable (WRDI)
The Write Disable (WRDI) instruction resets the Write Enable Latch (WEL) bit.
Apart form the parallelizing of the instruction code on the four pins DQ0, DQ1, DQ2 and
DQ3, the instruction functionality is exactly the same as the Write Disable (WRDI)
instruction of the Extended SPI protocol, please refer to Section 9.1.10: Write Disable
(WRDI) for further details.
Figure 78. Write Disable instruction sequence QIO-SPI
S
01
C
Instruction
DQ0
DQ1
DQ2
DQ3
9.3.6
Quad_Write_Disable
Quad Command Page Program (QCPP)
The Quad Command Page Program (QCPP) instruction allows to program the memory
content in DIO-SPI protocol, parallelizing the instruction code, the address and the input
data on four pins (DQ0, DQ1, DQ2 and DQ3). Before it can be accepted, a Write Enable
(WREN) instruction must previously have been executed. The Quad Command Page
Program (QCPP) instruction can be issued, when the device is set in QIO-SPI mode, by
sending to the memory indifferently one of the 3 instructions codes: 02h, 12h or 32h, the
effect is exactly the same. The 3 instruction codes are all accepted to help the application
code porting from Extended SPI protocol to QIO-SPI protocol.
Apart for the parallelizing on four pins of the instruction code, the Quad Command Page
Program instruction functionality is exactly the same as the Quad Input Extended Fast
Program of the Extended SPI protocol, please refer to Section 9.1.15: Quad Input Extended
Fast Program for further details.
139/185