English
Language : 

M306V2ME Datasheet, PDF (98/276 Pages) Mitsubishi Electric Semiconductor – SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER with CLOSED CAPTION DECODER and ON-SCREEN DISPLAY CONTROLLER 
MITSUBISHI MICROCOMPUTERS
M306V2ME-XXXFP
M306V2EEFP
SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER with CLOSED CAPTION DECODER
and ON-SCREEN DISPLAY CONTROLLER
(4) TB0IN noise filter
The input signal of pin TB0IN has the noise filter. The ON/OFF of noise filter and selection of filter clock
are set by bits 2 to 4 of the peripheral mode register.
Note: When using the noise filter, set bit 7 of the peripheral mode register according to the main clock
frequency.
Peripheral mode register
b7 b6 b5 b4 b3 b2 b1 b0
Symbol
PM
Address
027D16
When reset
0XX000002
Bit symbol
Bit name
BSEL0
I2C-BUS interface port
selection bits
BSEL1
WSEL0
WSEL1
Clock selection bits of
TB0IN noise filter
(Note)
Function
b1 b0
0 0 : None
0 1 : SCL1, SDA1
1 0 : SCL2, SDA2
1 1 : SCL1 and SDA1,
SCL2 and SDA2
RW
b3 b2
0 0 : 0.25 µs
(removed bus width: max 0.75 µs)
0 1 : 8 µs
(removed bus width: max 24 µs)
1 0 : 16 µs
(removed bus width: max 48 µs)
1 1 : 32 µs
(removed bus width: max 96 µs)
NFON
ON/OFF selection
0 : Noise filter OFF
bit of TB0IN pin noise filter 1 : Noise filter ON
Nothing is assigned.
In an attempt to write to this bit, write “0.” The value, if read, turns out to be
indeterminate.
SSCK
Main clock frequency
selection bit
0 : f(XIN) = 10 MHZ
1 : f(XIN) = 16 MHZ
Note: The operation of MCU is not guaranteed when f(XIN) = 16 MHz.
Figure 2.10.28 Peripheral mode register
Rev. 1.0
98