M306V2ME Datasheet, PDF (52/276 Pages) Mitsubishi Electric Semiconductor – SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER with CLOSED CAPTION DECODER and ON-SCREEN DISPLAY CONTROLLER

MITSUBISHI MICROCOMPUTERS
M306V2ME-XXXFP
M306V2EEFP
SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER with CLOSED CAPTION DECODER
and ON-SCREEN DISPLAY CONTROLLER
(2) Variable vector tables
The fixed vector table is a table in which addresses are fixed. The vector tables are located in an area
extending from FFFDC16 to FFFFF16. One vector table comprises four bytes. Set the first address of
interrupt routine in each vector table. Table 2.7.2 shows the interrupts assigned to the fixed vector
tables and addresses of vector tables.
Table 2.7.2 Interrupts assigned to the variable vector tables and addresses of vector tables
Software interrupt number
Software interrupt number 0
Vector table address
Address (L) to address (H)
Interrupt source
+0 to +3 (Note)
BRK instruction
Remarks
Cannot be masked I flag
Software interrupt number 4
Software interrupt number 5
+16 to +19 (Note)
+20 to +23 (Note)
OSD1
Reserved source
Software interrupt number 6
+24 to +27 (Note) Reserved source
Software interrupt number 7
+28 to +31 (Note) Reserved source
Software interrupt number 8
Software interrupt number 9
Software interrupt number 10
Software interrupt number 11
+32 to +35 (Note)
+36 to +39 (Note)
+40 to +43 (Note)
+44 to +47 (Note)
OSD2
Multi-master I²C-BUS interface 1
Bus collision detection
DMA0
Software interrupt number 12
Software interrupt number 13
+48 to +51 (Note)
+52 to +55 (Note)
DMA1
Multi-master I²C-BUS interface 0
Software interrupt number 14
+56 to +59 (Note)
A-D conversion
Software interrupt number 15
+60 to +63 (Note)
UART2 transmit
Software interrupt number 16
+64 to +67 (Note)
UART2 receive
Software interrupt number 17
+68 to +71 (Note)
UART0 transmit
Software interrupt number 18
Software interrupt number 19
+72 to +75 (Note)
+76 to +79 (Note)
UART0 receive
Data slicer
Software interrupt number 20
+80 to +83 (Note)
VSYNC
Software interrupt number 21
+84 to +87 (Note)
Timer A0
Software interrupt number 22
+88 to +91 (Note)
Timer A1
Software interrupt number 23
+92 to +95 (Note)
Timer A2
Software interrupt number 24
+96 to +99 (Note)
Timer A3
Software interrupt number 25 +100 to +103 (Note) Timer A4
Software interrupt number 26 +104 to +107 (Note) Timer B0
Software interrupt number 27 +108 to +111 (Note) Timer B1
Software interrupt number 28 +112 to +115 (Note) Timer B2
Software interrupt number 29
Software interrupt number 30
Software interrupt number 31
+116 to +119 (Note)
+120 to +123 (Note)
+124 to +127 (Note)
INT0
INT1
Reserved source
Software interrupt number 32
to
Software interrupt number 63
+128 to +131 (Note)
to
+252 to +255 (Note)
Software interrupt
Cannot be masked I flag
Note: Address relative to address in interrupt table register (INTB).
Rev. 1.0
52