M306V2ME Datasheet, PDF (58/276 Pages) Mitsubishi Electric Semiconductor – SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER with CLOSED CAPTION DECODER and ON-SCREEN DISPLAY CONTROLLER

MITSUBISHI MICROCOMPUTERS
M306V2ME-XXXFP
M306V2EEFP
SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER with CLOSED CAPTION DECODER
and ON-SCREEN DISPLAY CONTROLLER
Time (a) is dependent on the instruction under execution. Thirty cycles is the maximum required for the
DIVX instruction (without wait).
Time (b) is as shown in Table 2.7.5.
Table 2.7.5 Time required for executing the interrupt sequence
Interrupt vector address Stack pointer (SP) value 16-Bit bus, without wait
8-Bit bus, without wait
Even
Even
Even
Odd
18 cycles (Note 1)
19 cycles (Note 1)
20 cycles (Note 1)
20 cycles (Note 1)
Odd (Note 2)
Even
19 cycles (Note 1)
20 cycles (Note 1)
Odd (Note 2)
Odd
20 cycles (Note 1)
20 cycles (Note 1)
________
Notes 1: Add 2 cycles in the case of a DBC interrupt; add 1 cycle in the case either of an address coinci-
dence interrupt or of a single-step interrupt.
2: Locate an interrupt vector address in an even address, if possible.
BCLK
Address bus
Data bus
R
W
1
2
3
4
5
6
7
8
9
10 11 12 13 14 15 16 17 18
Address
0000
Interrupt
information
Indeterminate
Indeterminate
Indeterminate
SP-2
SP-4
vec
vec+2
PC
SP-2
SP-4
vec
vec+2
contents contents contents contents
The indeterminate segment is dependent on the queue buffer.
If the queue buffer is ready to take an instruction, a read cycle occurs.
Figure 2.7.5 Time required for executing the interrupt sequence
2.7.12 Variation of IPL when Interrupt Request is Accepted
If an interrupt request is accepted, the interrupt priority level of the accepted interrupt is set in the IPL.
If an interrupt request, that does not have an interrupt priority level, is accepted, one of the values shown
in Table 2.7.6 is set in the IPL.
Table 2.7.6 Relationship between interrupts without interrupt priority levels and IPL
Interrupt sources without priority levels
Value set in the IPL
Watchdog timer
7
Reset
Other
0
Not changed
58
Rev. 1.0