M306V2ME Datasheet, PDF (29/276 Pages) Mitsubishi Electric Semiconductor – SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER with CLOSED CAPTION DECODER and ON-SCREEN DISPLAY CONTROLLER

MITSUBISHI MICROCOMPUTERS
M306V2ME-XXXFP
M306V2EEFP
SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER with CLOSED CAPTION DECODER
and ON-SCREEN DISPLAY CONTROLLER
2.4.4 Bus Control
The following explains the signals required for accessing external devices and software waits. The sig-
nals required for accessing the external devices are valid when the processor mode is set to memory
expansion mode and microprocessor mode. The software waits are valid in all processor modes.
(1) Address bus/data bus
The address bus consists of the 20 pins A0 to A19 for accessing the 1M bytes of address space.
The data bus consists of the pins for data I/O. When the BYTE pin is “H”, the 8 ports D0 to D7 function
as the data bus. When BYTE is “L”, the 16 ports D0 to D15 function as the data bus.
When a change is made from single-chip mode to memory expansion mode, the value of the address
bus is undefined until external memory is accessed.
(2) Chip select signal
The chip select signal is output using the same pins as P44 to P47. Bits 0 to 3 of the chip select control
register (address 000816) set each pin to function as a port or to output the chip select signal. The chip
select control register is valid in memory expansion mode and microprocessor mode. In single-chip
mode, P44 to P47 function as programmable I/O ports regardless of the value in the chip select control
register.
_______
In microprocessor mode, only CS0 outputs the chip select signal after the reset state has been can-
_______
_______
celled. CS1 to CS3 function as input ports. Figure 2.4.4 shows the chip select control register.
The chip select signal can be used to split the external area into as many as four blocks. Table 2.4.4
shows the external memory areas specified using the chip select signal.
Table 2.4.3 External areas specified by the chip select signals
Chip select
CS0
CS1
CS2
CS3
Memory expansion mode
3000016 to 8FFFF16 (384K)
2800016 to 2FFFF16 (32K)
0800016 to 27FFF16 (128K)
0400016 to 07FFF16 (16K)
Specified address range
Microprocessor mode
3000016 to 8FFFF16 (384K), B0000 16 to FFFFF16 (320K)
2800016 to 2FFFF16 (32K)
0800016 to 27FFF16 (128K)
0400016 to 07FFF16 (16K)
Rev. 1.0
29