M306V2ME Datasheet, PDF (122/276 Pages) Mitsubishi Electric Semiconductor – SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER with CLOSED CAPTION DECODER and ON-SCREEN DISPLAY CONTROLLER

MITSUBISHI MICROCOMPUTERS
M306V2ME-XXXFP
M306V2EEFP
SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER with CLOSED CAPTION DECODER
and ON-SCREEN DISPLAY CONTROLLER
(1) Sleep mode (UART0)
This mode is used to transfer data between specific microcomputers among multiple microcomputers
connected using UART0. The sleep mode is selected when the sleep select bit (bit 7 at address
03A016) is set to “1” during reception. In this mode, the unit performs receive operation when the MSB
of the received data = “1” and does not perform receive operation when the MSB = “0”.
(2) Function for switching serial data logic (UART2)
When the data logic select bit (bit 6 of address 037D16) is assigned 1, data is inverted in writing to the
transmission buffer register or reading the reception buffer register. Figure 2.11.24 shows the ex-
ample of timing for switching serial data logic.
• When LSB first, parity enabled, one stop bit
Transfer clock ^{“H”}
“L”
TxD2 ^{“H”}
(no reverse) _{“L”}
TxD2 ^{“H”}
(reverse) _{“L”}
ST D0 D1 D2 D3 D4 D5 D6 D7 P SP
ST D0 D1 D2 D3 D4 D5 D6 D7 P SP
ST : Start bit
P : Even parity
SP : Stop bit
Figure 2.11.24 Timing for switching serial data logic
(3) TxD, RxD I/O polarity reverse function (UART2)
This function is to reverse TxD pin output and RxD pin input. The level of any data to be input or output
(including the start bit, stop bit(s), and parity bit) is reversed. Set this function to “0” (not to reverse) for
usual use.
Rev. 1.0
122