|
PIC18F4539 Datasheet, PDF (287/322 Pages) Microchip Technology – Enhanced FLASH Microcontrollers with Single Phase Induction Motor Control Kernel | |||
|
◁ |
PIC18FXX39
TABLE 23-21: A/D CONVERTER CHARACTERISTICS: PIC18FXX39 (INDUSTRIAL, EXTENDED)
PIC18LFXX39 (INDUSTRIAL)
Param
No.
Symbol
Characteristic
Min
Typ
Max
Units
Conditions
A01 NR
Resolution
â
â
10
bit
A03 EIL
Integral linearity error
â
â
<±1
LSb VREF = VDD = 5.0V
A04 EDL
Differential linearity error
â
â
<±1
LSb VREF = VDD = 5.0V
A05 EG
Gain error
â
â
<±1
LSb VREF = VDD = 5.0V
A06 EOFF Offset error
â
â
<±1.5
LSb VREF = VDD = 5.0V
A10 â
Monotonicity
guaranteed(2)
â VSS ⤠VAIN ⤠VREF
A20 VREF
A20A
Reference Voltage
(VREFH â VREFL)
1.8V
â
3V
â
â
V VDD < 3.0V
â
V VDD ⥠3.0V
A21 VREFH Reference voltage High
AVSS
â AVDD + 0.3V V
A22 VREFL Reference voltage Low
AVSS â 0.3V â
VREFH
V
A25 VAIN Analog input voltage
AVSS â 0.3V â AVDD + 0.3V V VDD ⥠2.5V (Note 3)
A30 ZAIN Recommended impedance of
â
â
2.5
k⦠(Note 4)
analog voltage source
A50 IREF
VREF input current (Note 1)
â
â
5
µA During VAIN acquisition
â
â
150
µA During A/D conversion cycle
Note 1: Vss ⤠VAIN ⤠VREF
2: The A/D conversion result never decreases with an increase in the Input Voltage, and has no missing codes.
3: For VDD < 2.5V, VAIN should be limited to < .5 VDD.
4: Maximum allowed impedance for analog voltage source is 10 kâ¦. This requires higher acquisition times.
FIGURE 23-22: A/D CONVERSION TIMING
BSF ADCON0, GO
(Note 2)
131
Q4
130
A/D CLK
132
A/D DATA
9
8
7 ... ... 2
1
0
ADRES
ADIF
GO
SAMPLE
OLD_DATA
SAMPLING STOPPED
NEW_DATA
TCY
DONE
Note 1: If the A/D clock source is selected as RC, a time of TCY is added before the A/D clock starts.
This allows the SLEEP instruction to be executed.
2: This is a minimal RC delay (typically 100 ns), which also disconnects the holding capacitor from the analog input.
 2002 Microchip Technology Inc.
Preliminary
DS30485A-page 285
|
▷ |