PIC18F4539 Datasheet, PDF (263/322 Pages) Microchip Technology – Enhanced FLASH Microcontrollers with Single Phase Induction Motor Control Kernel

PIC18FXX39
23.1 DC Characteristics: PIC18FXX39 (Industrial, Extended)
PIC18LFXX39 (Industrial)
PIC18LFXX39
(Industrial)
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40°C ≤ TA ≤ +85°C for industrial
PIC18FXX39
(Industrial, Extended)
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40°C ≤ TA ≤ +85°C for industrial
-40°C ≤ TA ≤ +125°C for extended
Param
No.
Symbol
Characteristic
Min Typ Max Units
Conditions
VDD Supply Voltage
D001
PIC18LFXX39 2.0 — 5.5 V HS Osc mode
D001
PIC18FXX39 4.2 — 5.5 V
D002 VDR
RAM Data Retention
Voltage⁽¹⁾
1.5 — — V
D003 VPOR VDD Start Voltage
—
to ensure internal
Power-on Reset signal
— 0.7 V See Section 3.1 (Power-on Reset) for details
D004 SVDD VDD Rise Rate
0.05 —
to ensure internal
Power-on Reset signal
— V/ms See Section 3.1 (Power-on Reset) for details
VBOR Brown-out Reset Voltage
D005
PIC18LFXX39
BORV1:BORV0 = 11 1.98 — 2.14 V 85°C ≥ T ≥ 25°C
BORV1:BORV0 = 10 2.67 — 2.89 V
BORV1:BORV0 = 01 4.16 — 4.5 V
BORV1:BORV0 = 00 4.45 — 4.83 V
D005
PIC18FXX39
BORV1:BORV0 = 1x N.A. — N.A. V Not in operating voltage range of device
BORV1:BORV0 = 01 4.16 — 4.5 V
BORV1:BORV0 = 00 4.45 — 4.83 V
Legend: Shading of rows is to assist in readability of the table.
Note 1: This is the limit to which VDD can be lowered in SLEEP mode, or during a device RESET, without losing RAM data.
2: The supply current is mainly a function of the operating voltage and frequency. Other factors, such as I/O pin
loading and switching rate, oscillator type, internal code execution pattern and temperature, also have an
impact on the current consumption.
The test conditions for all IDD measurements in active Operation mode are:
OSC1 = external square wave, from rail-to-rail; all I/O pins tri-stated, pulled to VDD
MCLR = VDD; WDT enabled/disabled as specified.
3: The power-down current in SLEEP mode does not depend on the oscillator type. Power-down current is
measured with the part in SLEEP mode, with all I/O pins in hi-impedance state and tied to VDD or VSS, and all
features that add delta current disabled (such as WDT, Timer1 Oscillator, BOR, etc.).
4: The LVD and BOR modules share a large portion of circuitry. The ∆IBOR and ∆ILVD currents are not additive.
Once one of these modules is enabled, the other may also be enabled without further penalty.
 2002 Microchip Technology Inc.
Preliminary
DS30485A-page 261