PIC18F4539 Datasheet, PDF (267/322 Pages) Microchip Technology – Enhanced FLASH Microcontrollers with Single Phase Induction Motor Control Kernel

PIC18FXX39
23.2 DC Characteristics: PIC18FXX39 (Industrial, Extended)
PIC18LFXX39 (Industrial) (Continued)
DC CHARACTERISTICS
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40°C ≤ TA ≤ +85°C for industrial
-40°C ≤ TA ≤ +125°C for extended
Param
No.
Symbol
Characteristic
Min
Max Units
Conditions
VOL
Output Low Voltage
D080
I/O ports
—
0.6
V IOL = 8.5 mA, VDD = 4.5V,
-40°C to +85°C
D080A
VOH
Output High Voltage⁽²⁾
—
0.6
V IOL = 7.0 mA, VDD = 4.5V,
-40°C to +125°C
D090
I/O ports
VDD – 0.7
—
V IOH = -3.0 mA, VDD = 4.5V,
-40°C to +85°C
D090A
VDD – 0.7
—
V IOH = -2.5 mA, VDD = 4.5V,
-40°C to +125°C
D150 VOD Open Drain High Voltage
—
8.5
V RA4 pin
Capacitive Loading Specs
on Output Pins
D100⁽³⁾ COSC2 OSC2 pin
—
15
pF In HS mode when external
clock is used to drive OSC1
D101 CIO
All I/O pins
—
50
pF To meet the AC Timing
Specifications
D102 CB
SCL, SDA
—
400
pF In I²C mode
Note 1: The leakage current on the MCLR pin is strongly dependent on the applied voltage level. The specified
levels represent normal operating conditions. Higher leakage current may be measured at different input
voltages.
2: Negative current is defined as current sourced by the pin.
3: Parameter is characterized but not tested.
 2002 Microchip Technology Inc.
Preliminary
DS30485A-page 265