82551QM Datasheet, PDF (35/120 Pages) Intel Corporation – Fast Ethernet Multifunction PCI/CardBus Controller

Networking Silicon — 82551QM
If PME is enabled (in the PCI power management registers), the RST# signal does not affect any
PME related circuits (in other words, the CSTSCHG registers (CardBus only), PCI power
management registers, and the wake-up packet would not be affected).
Note: The PCI Specification, Revision 2.2, states that the RST# signal should be active low in the B3
state. (In PCI Specification, Revision 2.1, the RST# signal is undefined during the B3 state.)
The transition from the B3 bus power state to the B0 bus power state occurs on the trailing edge of
the RST# signal.
The initialization signal is generated internally in the following cases:
• Active RST# signal while the 82551QM is the D0, D1, or D2 power state
• RST# trailing edge while the 82551QM is in the D3 power state
• ISOLATE# trailing edge
The internal initialization signal resets the PCI Configuration Space, MAC configuration, and
memory structure.
The behavior of the RST# and ISOLATE# pins and the internal 82551QM initialization signal are
shown in the following figure.
Figure 9. Initialization upon RST# and ISOLATE#
RST#
Internal hardware
reset
D0 - D2 power state
RST#
Internal hardware
reset
ISOLATE#
Internal hardware
reset
D3 power state
640 ns
Internal reset
due to ISOLATE#
640 ns
Datasheet
29