MC68HC705P9 Datasheet, PDF (76/160 Pages) Motorola, Inc – HCMOS Microcontroller Unit

Freescale Semiconductor, Inc.
Low Power Modes
When the MCU exits stop mode, processing resumes after a
stabilization delay of 4064 oscillator cycles.
An active edge on the PD7/TCAP pin during stop mode sets the ICF flag
when an external interrupt brings the MCU out of stop mode. An external
interrupt also latches the value in the timer registers into the input
capture registers.
If a reset brings the MCU out of stop mode, then an active edge on the
PD7/TCAP pin during stop mode has no effect on the ICF flag or the
input capture registers.
See Figure 6-1 for stop recovery timing information.
OSC
(NOTE 1)
t_RL
RESET
IRQ/V_PP
t_ILIH
(NOTE 2)
IRQ/V_PP
(NOTE 3)
4064 t_CYC
INTERNAL
CLOCK
INTERNAL
ADDRESS
BUS
1FFE
(NOTE 4)
1FFE
1FFE
1FFE
1FFE
1FFF
Notes:
1. Internal clocking from OSC1 pin
2. Edge-triggered external interrupt mask option
3. Edge- and level-triggered external interrupt mask option
4. Reset vector shown as example
RESET OR INTERRUPT
VECTOR FETCH
Figure 6-1. Stop Recovery Timing
Technical Data
76
Low Power Modes
For More Information On This Product,
Go to: www.freescale.com
MC68HC705P9 — Rev. 4.0
MOTOROLA