NP8P128A13BSM60E Datasheet, PDF (58/92 Pages) Numonyx B.V – 128-Mbit Parallel Phase Change Memory

Numonyx® Omneo™ P8P Datasheet
14.0 Max Ratings and Operating Conditions
14.1
Absolute Maximum Ratings
Warning:
Stressing the device beyond the “Absolute Maximum Ratings” may cause permanent
damage. These are stress ratings only.
Table 23: Absolute Maximum Ratings
Parameter
Voltage on any signal (except V_CC, Vccq, V_PP)⁽¹⁾
V_PP voltage^(2,4)
V_CC voltage^(2,4)
V_CCQ voltage^(2,4,5)
Output short circuit current⁽³⁾
Maximum Rating
–2.0 V to +5.6v, <20ns
–2.0 V to +5.6v, <20ns
–2.0 V to +5.6v, <20ns
–2.0 V to +5.6v, <20ns
100 mA
Notes:
1.
All specified voltages are with respect to Vss. During infrequent non-periodic transitions, the voltage potential between Vss
and input/output pins may undershoot to -2.0v for periods <20 ns or overshoot to VCCQ + 2.0v for periods <20 ns.
2.
During infrequent non-periodic transitions the voltage potential between Vss and the supplies may undershoot to -2.0v for
periods <20 ns or overshoot to VSUPPLY (max) + 2.0v for periods <20 ns.
3.
Output shorted for no more than one second. No more than one output shorted at a time.
4.
For functional operating voltages, please refer to Section 27, “DC Voltage Characteristics” on page 61
5.
Make sure that V_CCQ is less or equal to V_CC in value, otherwise the device fails to operate correctly” in the next revision of
the datasheet.
14.2
Operating Conditions
Note: Operation beyond the “Operating Conditions” is not recommended and extended exposure
beyond the “Operating Conditions” may affect device reliability.
Table 24: Operating Conditions
Symbol
Parameter
Min
Max
Units
T_C
T_C
V_CC
V_CCQ
Operating Temperature (115 ns)
Operating Temperature (135 ns)
V_CC Supply Voltage
I/O Supply Voltage
CMOS inputs
TTL inputs
0
+70
°C
-30
+85
°C
2.7
3.6
1.7
3.6
V
2.4
3.6
V_PP
V_PP Voltage Supply (Logic Level)
0.9
3.6
Notes:
1.
T_C = Case Temperature.
2.
V_CCQ = 1.7v - 3.6v range is intended for CMOS inputs and the 2.4v - 3.6v is intended for TTL inputs.
3.
In typical operation VPP program voltage is V_PPL.
Notes
1
2
3
Datasheet
58
July 2010
316144-07