M16C Datasheet, PDF (43/262 Pages) Mitsubishi Electric Semiconductor – SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER

Preliminary Specifications REV.B
Mitsubishi microcomputers
Specifications in this manual are tentative and subject to change.
M16C / 6N Group
SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER
Clock Generating Circuit
Clock Output
In single-chip mode, the clock output function select bits (bits 0 and 1 at address 000616) enable f8, f32, or fc
to be output from the P57/CLKOUT pin. When the WAIT peripheral function clock stop bit (bit 2 at address
000616) is set to “1”, the output of f8 and f32 stops when a WAIT instruction is executed.
Stop Mode
Writing “1” to the all-clock stop control bit (bit 0 at address 000716) stops all oscillation and the microcom-
puter enters stop mode. In stop mode, the content of the internal RAM is retained provided that VCC remains
above 2V.
Because the oscillation of BCLK, f2 to f32, fc, fc32, fcAN0, fcAN1 and fAD2 stops in stop mode, peripheral
functions such as the A-D converter and watchdog timer do not function. However, timer A and timer B
operate provided that the event counter mode is set to an external pulse, and UARTi(i = 0 to 2) functions
provided an external clock is selected. Table 5-2 shows the status of the ports in stop mode.
Stop mode is cancelled by a hardware reset or interrupt. If an interrupt is to be used to cancel stop mode,
that interrupt must first have been enabled.
When shifting to stop mode, the main clock division select bit 0 (bit 6 at 000616) is set to “1”.
Table 5-2. Port status during stop mode
Pin
Address bus, data bus, CS0 to CS3
RD, WR, BHE, WRL, WRH
HLDA, BCLK
ALE
Port
CLKOUT When fc selected
When f8, f32 selected
Memory expansion mode
Microprocessor mode
Single-chip mode
Retains status before stop mode
“H”
“H”
“H”
Retains status before stop mode Retains status before stop mode
Valid only in single-chip mode “H”
Valid only in single-chip mode Retains status before stop mode
43