M16C Datasheet, PDF (121/262 Pages) Mitsubishi Electric Semiconductor – SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER

Preliminary Specifications REV.B
Mitsubishi microcomputers
Specifications in this manual are tentative and subject to change.
M16C / 6N Group
SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER
CSelorciakl sI/yOnchronous serial I/O mode
Table 12-3. Specifications of clock synchronous serial I/O mode (2)
Item
Select function
Specification
• CLK polarity selection
Whether transmit data is output/input at the rising edge or falling edge of the
transfer clock can be selected
• LSB first/MSB first selection
Whether transmission/reception begins with bit 0 or bit 7 can be selected
• Continuous receive mode selection
Reception is enabled simultaneously by a read from the receive buffer register
• Transfer clock output from multiple pins selection (UART1) (Note)
UART1 transfer clock can be chosen by software to be output from one of
the two pins set
• Separate CTS/RTS pins (UART0) (Note)
UART0 CTS and RTS pins each can be assigned to separate pins
• Switching serial data logic (UART2)
Whether to reverse data in writing to the transmission buffer register or
reading the reception buffer register can be selected.
• TxD, RxD I/O polarity reverse (UART2)
This function is reversing TxD port output and RxD port input. All I/O data
level is reversed.
Note: The transfer clock output from multiple pins and the separate CTS/RTS pins functions cannot be
selected simultaneously.
121