|
M1A3P250-VQ100 Datasheet, PDF (203/210 Pages) Microsemi Corporation – ProASIC3 Flash Family FPGAs with Optional Soft ARM Support | |||
|
◁ |
Revision
v2.0
(April 2007)
ProASIC3 Flash Family FPGAs
Changes
In the "Packaging Tables", Ambient was deleted.
Page
ii
The timing characteristics tables were updated.
N/A
The "PLL Macro" section was updated to add information on the VCO and PLL 2-15
outputs during power-up.
The "PLL Macro" section was updated to include power-up information.
2-15
Table 2-11 ⢠ProASIC3 CCC/PLL Specification was updated.
2-29
Figure 2-19 ⢠Peak-to-Peak Jitter Definition is new.
2-18
The "SRAM and FIFO" section was updated with operation and timing 2-21
requirement information.
The "RESET" section was updated with read and write information.
2-25
The "RESET" section was updated with read and write information.
2-25
The "Introduction" in the "Advanced I/Os" section was updated to include 2-28
information on input and output buffers being disabled.
PCI-X 3.3 V was added to Table 2-11 ⢠VCCI Voltages and Compatible 2-29
Standards.
In the Table 2-15 ⢠Levels of Hot-Swap Support, the ProASIC3 compliance 2-34
descriptions were updated for levels 3 and 4.
Table 2-43 ⢠I/O Hot-Swap and 5 V Input Tolerance Capabilities in ProASIC3 2-64
Devices was updated.
Notes 3, 4, and 5 were added to Table 2-17 ⢠Comparison Table for 5 Vâ
Compliant Receiver Scheme. 5 x 52.72 was changed to 52.7 and the Maximum
current was updated from 4 x 52.7 to 5 x 52.7.
2-40
The "VCCPLF PLL Supply Voltage" section was updated.
2-50
The "VPUMP Programming Supply Voltage" section was updated.
2-50
The "GL Globals" section was updated to include information about direct input 2-51
into quadrant clocks.
VJTAG was deleted from the "TCK Test Clock" section.
In Table 2-22 ⢠Recommended Tie-Off Values for the TCK and TRST Pins, TSK
was changed to TCK in note 2. Note 3 was also updated.
2-51
2-51
Ambient was deleted from Table 3-2 ⢠Recommended Operating Conditions. 3-2
VPUMP programming mode was changed from "3.0 to 3.6" to "3.15 to 3.45".
Note 3 is new in Table 3-4 ⢠Overshoot and Undershoot Limits (as measured on 3-2
quiet I/Os)1.
In EQ 3-2, 150 was changed to 110 and the result changed from 3.9 to 1.951.
3-5
Table 3-6 ⢠Temperature and Voltage Derating Factors for Timing Delays was 3-6
updated.
Table 3-5 ⢠Package Thermal Resistivities was updated.
3-5
Table 3-14 ⢠Summary of Maximum and Minimum DC Input and Output Levels 3-17 to 3-
Applicable to Commercial and Industrial ConditionsâSoftware Default Settings 17
(Advanced) and Table 3-17 ⢠Summary of Maximum and Minimum DC Input
Levels Applicable to Commercial and Industrial Conditions (Standard Plus) were
updated.
Revision 15
5-7
|
▷ |