PIC18F67J11T-I Datasheet, PDF (146/466 Pages) Microchip Technology – 64/80-Pin, High-Performance, 1-Mbit Flash Microcontrollers

PIC18F87J11 FAMILY
11.4 PORTC, TRISC and
LATC Registers
PORTC is an 8-bit wide, bidirectional port. Only
PORTC pins, RC2 through RC7, are digital only pins
and can tolerate input voltages up to 5.5V.
PORTC is multiplexed with ECCP, MSSPx and
EUSARTx peripheral functions (Table 11-8). The pins
have Schmitt Trigger input buffers. The pins for ECCP,
SPI and EUSARTx are also configurable for open-drain
output whenever these functions are active. Open-drain
configuration is selected by setting the SPIxOD,
ECCPxOD, and UxOD control bits in the ODCON regis-
ters (see Section 11.1.3 “Pull-up Configuration” for
more information).
RC1 is normally configured as the default peripheral
pin for the ECCP2 module. Assignment of ECCP2 is
controlled by Configuration bit, CCP2MX (default state,
CCP2MX = 1).
When enabling peripheral functions, care should be
taken in defining TRIS bits for each PORTC pin. Some
peripherals override the TRIS bit to make a pin an output,
while other peripherals override the TRIS bit to make a
pin an input. The user should refer to the corresponding
peripheral section for the correct TRIS bit settings.
Note: These pins are configured as digital inputs
on any device Reset.
The contents of the TRISC register are affected by
peripheral overrides. Reading TRISC always returns
the current contents, even though a peripheral device
may be overriding one or more of the pins.
EXAMPLE 11-4: INITIALIZING PORTC
CLRF
CLRF
MOVLW
MOVWF
PORTC
LATC
H'CF'
TRISC
; Initialize PORTC by
; clearing output
; data latches
; Alternate method to clear
; output data latches
; Value used to initialize
; data direction
; Set RC<3:0> as inputs
; RC<5:4> as outputs
; RC<7:6> as inputs
DS39778E-page 146
 2007-2012 Microchip Technology Inc.