|
MB86293 Datasheet, PDF (82/285 Pages) Fujitsu Component Limited. – Grraphiics Conttrrollllerr Speciiffiicattiions | |||
|
◁ |
FUJITSU LIMITED
PRELIMINARY and CONFIDENTIAL
8.4.3 Texture lapping
If a negative or larger than the specified texture pattern size is specified as the texture coordinates (S, T),
according to the setting, one of these options (repeat, cramp or border) is selected for the âout-of-rangeâ
texture mapping. The mapping image for each case is shown below:
Repeat
Cramp
Border
Repeat
This just simply masks the upper bits of the applied (S, T) coordinates. When the texture pattern size
is 64 Ã 64 pixels, the lower 6 bits of the integer part of (S, T) coordinates are used for S and T
coordinates.
Cramp
When the applied (S, T) coordinates is either negative or larger than the specified texture pattern size,
cramp the (S, T) coordinate as follows instead of texture:
S<0
S > Texture X size â 1
S=0
S = Texture X size â 1
Border
When the applied (S, T) coordinate is either negative or larger than the specified texture pattern size,
the outside of the specified texture pattern is rendered in the âborderâ color.
MB86293 CORAL_LQ
Graphics Controller
82
Specifications Rev. 1.1
|
▷ |