|
MB86294 Datasheet, PDF (155/305 Pages) Fujitsu Component Limited. – Grraphiics Controller specifications | |||
|
◁ |
FUJITSU LIMITED
PRELIMINARY and CONFIDENTIAL
LSA (displayList Source Address)
Register
address
HostBaseAddress + 40H
Bit number 31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
Bit field name
Reserved
LSA
R/W
R0
RW
R0
Initial value
0
Donât care
0
This register sets the DisplayList transfer source address. When DisplayList is transferred from
Graphics Memory, set the transfer start address of DisplayList stored in Graphics Memory. Since the
lower two bits of this register are always treated as â0â, DisplayList must be 4-byte aligned. The
values set at this register do not change during or after transfer.
LCO (displayList Count)
Register
address
HostBaseAddress + 44H
Bit number 31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
Bit field name
Reserved
LCO
R/W
R0
RW
Initial value
0
Donât care
This register sets the DisplayList transfer count. Set the display list transfer count by the long word.
When â1hâ is set, 1-word data is transferred. When â0â is set, it is considered to be the maximum
count and 16M (16,777,216) words of data are transferred. The values set at this register do not
change during or after transfer.
LREQ (displayList transfer REQuest)
Register
address
HostBaseAddress + 48H
Bit number
7
6
5
4
3
Bit field name
Reserved
R/W
R0
Initial value
0
2
1
0
LREQ
RW1
0
This register triggers DisplayList transfer from the Graphics Memory. Transfer is started by setting
LREQ to â1â. The DisplayList is transferred from the Graphics Memory to the internal display list FIFO.
Access to the display list FIFO by the CPU or DMA is disabled during transfer.
MB86294/294S CORAL_LB
Graphics Controller
155
Specifications Rev. 1.0
|
▷ |