MC68HC05X16 Datasheet, PDF (134/232 Pages) Freescale Semiconductor, Inc – High-density complementary metal oxide semiconductor HCMOS) microcontroller unit

Freescale Semiconductor, Inc.
9.4
A/D converter during WAIT mode
The A/D converter is not affected by WAIT mode and continues normal operation.
In order to reduce power consumption the A/D converter can be disconnected, under software
control using the ADON bit and the ADRC bit in the A/D status/control register at $0009, before
entering WAIT mode.
9.5
Port D analog input
The external analog voltage value to be processed by the A/D converter is sampled on an internal
capacitor through a resistive path, provided by input-selection switches and a sampling aperture
time switch, as shown in Figure 9-2. Sampling time is limited to 12 bus clock cycles. After sampling,
the analog value is stored on the capacitor and held until the end of conversion. During this hold
time, the analog input is disconnected from the internal A/D system and the external voltage
source sees a high impedance input.
The equivalent analog input during sampling is an RC low-pass filter with a minimum resistance
of 50 kΩ and a capacitance of at least 10pF. It should be noted that these are typical values
measured at room temperature.
Input protection device
Analog
≥ 50kΩ
9
input
pin
+ ~20V
< 2pF
- ~0.7V
400 nA
junction
leakage
≥ 10pF
DAC
capacitance
Note:
V_RL
The analog switch is closed during the 12 cycle sample
time only.
Figure 9-2 Electrical model of an A/D input pin
ANALOG TO DIGITAL CONVERTER
MC68HC05X16
For More Information On This Product,
Rev. 1
Go to: www.freescale.com