AK4497 Datasheet, PDF (76/98 Pages) Asahi Kasei Microsystems – Quality Oriented 32-Bit 2ch DAC

[AK4497]
(2) I²C-bus Control Mode (I2C pin = “H”)
The AK4497 supports the fast-mode I²C-bus (max: 400kHz, Ver 1.0).
(2)-1. WRITE Operations
Figure 60 shows the data transfer sequence for the I²C-bus mode. All commands are preceded by a
START condition. A HIGH to LOW transition on the SDA line while SCL is HIGH indicates a START
condition (Figure 66). After the START condition, a slave address is sent. This address is 7 bits long
followed by the eighth bit that is a data direction bit (R/W). The most significant five bits of the slave
address are fixed as “00100”. The next bits are CAD1 and CAD0 (device address bits). This bit identifies
the specific device on the bus. The hard-wired input pin (CAD1pins, CAD0 pin) sets these device address
bits (Figure 61). If the slave address matches that of the AK4497, the AK4497 generates an acknowledge
and the operation is executed. The master must generate the acknowledge-related clock pulse and
release the SDA line (HIGH) during the acknowledge clock pulse (Figure 67). A R/W bit value of “1”
indicates that the read operation is to be executed, and “0” indicates that the write operation is to be
executed.
The second byte consists of the control register address of the AK4497 and the format is MSB first.
(Figure 62). The data after the second byte contains control data. The format is MSB first, 8bits (Figure
63). The AK4497 generates an acknowledge after each byte is received. Data transfer is always
terminated by a STOP condition generated by the master. A LOW to HIGH transition on the SDA line
while SCL is HIGH defines a STOP condition (Figure 66).
The AK4497 can perform more than one byte write operation per sequence. After receipt of the third byte
the AK4497 generates an acknowledge and awaits the next data. The master can transmit more than one
byte instead of terminating the write cycle after the first data byte is transferred. After receiving each data
packet the internal address counter is incremented by one, and the next data is automatically taken into
the next address. If the address exceeds “15H” prior to generating a stop condition, the address counter
will “roll over” to “00H” and the previous data will be overwritten.
The data on the SDA line must remain stable during the HIGH period of the clock. HIGH or LOW state of
the data line can only be changed when the clock signal on the SCL line is LOW (Figure 68) except for the
START and STOP conditions.
SDA
S
T
S
A
R/W= “0”
T
R
O
T
P
S
Slave
Address
Sub
Address(n)
Data(n)
Data(n+1)
Data(n+x)
P
A
A
A
A
A
A
C
C
C
C
C
C
K
K
K
K
K
K
Figure 60. Data Transfer Sequence at I²C Bus Mode
0
0
1
0
0 CAD1 CAD0 R/W
(CAD0 is set by the pin)
Figure 61. The First Byte
0
0
0
A4
A3
A2
A1
A0
Figure 62. The Second Byte
D7 D6 D5 D4 D3 D2 D1 D0
Figure 63. The Third Byte and After The Third Byte
Rev. 0.1
- 76 -
2015/11