W90N745CD Datasheet, PDF (142/422 Pages) Winbond – 16/32-bit ARM microcontroller

W90N745CD/W90N745CDG
Continued.
BITS
[22]
[21]
[20]
[19]
LC
TXABT
NCS
EXDEF
DESCRIPTIONS
The Late Collision Interrupt high indicates the collision occurred in the
outside of 64 bytes collision window. This means after the 64 bytes of a
frame has transmitted out to the network, the collision still occurred.
The late collision check will only be done while EMC is operating on
half-duplex mode.
If the LC is high and EnLC of MIEN register is enabled, the TxINTR will
be high. Write 1 to this bit clears the LC status.
1’b0: No collision occurred in the outside of 64 bytes collision window.
1’b1: Collision occurred in the outside of 64 bytes collision window.
The Transmit Abort Interrupt high indicates the packet incurred 16
consecutive collisions during transmission, and then the transmission
process for this packet is aborted. The transmission abort is only
available while EMC is operating on half-duplex mode.
If the TXABT is high and EnTXABT of MIEN register is enabled, the
TxINTR will be high. Write 1 to this bit clears the TXABT status.
1’b0: Packet doesn’t incur 16 consecutive collisions during
transmission.
1’b1: Packet incurred 16 consecutive collisions during transmission.
The No Carrier Sense Interrupt high indicates the MII I/F signal CRS
doesn’t active at the start of or during the packet transmission. The
NCS is only available while EMC is operating on half-duplex mode.
If the NCS is high and EnNCS of MIEN register is enabled, the TxINTR
will be high. Write 1 to this bit clears the NCS status.
1’b0: CRS signal actives correctly.
1’b1: CRS signal doesn’t active at the start of or during the packet
transmission.
The Defer Exceed Interrupt high indicates the frame waiting for
transmission has deferred over 0.32768ms on 100Mbps mode, or
3.2768ms on 10Mbps mode. The deferral exceed check will only be
done while bit NDEF of MCMDR is disabled, and EMC is operating on
half-duplex mode.
If the EXDEF is high and EnEXDEF of MIEN register is enabled, the
TxINTR will be high. Write 1 to this bit clears the EXDEF status.
1’b0: Frame waiting for transmission has not deferred over 0.32768ms
(100Mbps) or 3.2768ms (10Mbps).
1’b1: Frame waiting for transmission has deferred over 0.32768ms
(100Mbps) or 3.2768ms (10Mbps).
Publication Release Date: September 22, 2006
- 137 -
Revision A2